EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Machining Accuracy Prediction of Thin-Walled Components in Milling Based on Multi-Source Dynamic Signals

Zhipeng Jiang, Xiangwei Liu, Xiaolin An, Xianli Liu, Aisheng Jiang, Guohua Zheng

Coatings · 27.02.2026 · 16 (3) · 295

DOI: 10.3390/coatings16030295 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Coatings, online erschienen am 27.02.2026. Verfasst von Zhipeng Jiang und 5 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 27 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Thin-walled components used in aerospace manufacturing are highly susceptible to machining-induced deformation due to their low structural stiffness and dynamic cutting instability. Although signal-based modeling approaches have been reported for machining process monitoring and performance evaluation, deformation prediction of thin-walled structures requires explicit consideration of structural flexibility. To address this challenge, a deformation error prediction framework integrating multi-source dynamic machining signals with static structural flexibility characteristics is proposed, enabling simultaneous representation of process dynamics and structural response. Kernel principal component analysis (KPCA) is employed to reduce the feature dimensionality, and the extracted low-dimensional features are subsequently used as inputs for a kernel-based support vector regression (KSVR) model to establish the prediction framework. The proposed method was validated through 25 milling experiments conducted on Al7075-T6 thin-walled workpieces, where deformation error was measured at predefined monitoring points under varying process conditions. The results indicate that the proposed model achieves high predictive accuracy for machining-induced deformation, with RMSE values below 13 μm and R2 exceeding 0.89 on both validation and testing datasets, demonstrating strong agreement between predicted and experimental results. In addition, machining vibration amplitude exhibits a consistent correlation with deformation error, confirming that increased energy input and cutting instability significantly exacerbate thin-walled workpiece deformation.

Zitieren

APA

Jiang, Z., Liu, X., An, X., Liu, X., Jiang, A., & Zheng, G. (2026). Machining Accuracy Prediction of Thin-Walled Components in Milling Based on Multi-Source Dynamic Signals. Coatings, 16(3), 295. https://doi.org/10.3390/coatings16030295

Vancouver

Jiang Z, Liu X, An X, Liu X, Jiang A, Zheng G. Machining Accuracy Prediction of Thin-Walled Components in Milling Based on Multi-Source Dynamic Signals. Coatings. 2026;16(3):295. doi:10.3390/coatings16030295

BibTeX
@article{Jiang2026,
  author = {Jiang, Zhipeng and Liu, Xiangwei and An, Xiaolin and Liu, Xianli and Jiang, Aisheng and Zheng, Guohua},
  title = {Machining Accuracy Prediction of Thin-Walled Components in Milling Based on Multi-Source Dynamic Signals},
  journal = {Coatings},
  year = {2026},
  volume = {16},
  number = {3},
  pages = {295},
  doi = {10.3390/coatings16030295}
}
Kostenlos starten →