Influence of Mo Content on the Microstructure and Mechanical Properties of Cu-Mo Composites Fabricated by Mechanical Alloying and Spark Plasma Sintering
Coatings · 27.11.2025 · 15 (12) · 1387
DOI: 10.3390/coatings15121387 ↗Kurz gefasst
Fachartikel in der Zeitschrift Coatings, online erschienen am 27.11.2025. Verfasst von Jie Wu und 2 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 44 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Henan Soft Science Research Plan Key Project, Young Backbone Teacher Training Program of Henan University of Science and Technology.
Abstract (Originalsprache)
In this work, Mo particles were incorporated into a Cu matrix, with the hope of retaining the advantageous properties of Cu while improving its mechanical performance. Mechanical ball milling was employed to fabricate Cu-Mo composite powders with different Mo concentrations; the Mo particles were incorporated at mass fractions of 5%, 10%, 15%, and 20%, which were subsequently densified by spark plasma sintering (SPS) to achieve a high-density composite. Phase identification and microstructural analysis were performed using X-ray diffraction (XRD). Tensile strength, compressive strength, and Vickers hardness measurements were performed to evaluate the mechanical performance of the Cu-Mo composite. Microstructural characterization of the tensile specimen was conducted via electron backscatter diffraction (EBSD), energy dispersive X-ray spectroscopy (EDS), and field-emission scanning electron microscopy (FE-SEM). The results demonstrate a consistent decrease in grain size and a corresponding increase in density with higher Mo content in the composite. For Cu-15wt%Mo composite, the Vickers hardness is 135 HV, compressive strength is 300 MPa, and tensile strength is 371 MPa. Compared with pure Cu, they were increased by 74%, 115%, and 64%, respectively. The main strengthening mechanisms have been revealed. This research can offer a foundation and reference for designing and developing high-performance Cu-Mo composite.
Förderung
- Henan Soft Science Research Plan Key Project
- Young Backbone Teacher Training Program of Henan University of Science and Technology
Zitieren
APA
Wu, J., Li, X., & Yang, Q. (2025). Influence of Mo Content on the Microstructure and Mechanical Properties of Cu-Mo Composites Fabricated by Mechanical Alloying and Spark Plasma Sintering. Coatings, 15(12), 1387. https://doi.org/10.3390/coatings15121387
Vancouver
Wu J, Li X, Yang Q. Influence of Mo Content on the Microstructure and Mechanical Properties of Cu-Mo Composites Fabricated by Mechanical Alloying and Spark Plasma Sintering. Coatings. 2025;15(12):1387. doi:10.3390/coatings15121387
BibTeX
@article{Wu2025,
author = {Wu, Jie and Li, Xiuqing and Yang, Qingxia},
title = {Influence of Mo Content on the Microstructure and Mechanical Properties of Cu-Mo Composites Fabricated by Mechanical Alloying and Spark Plasma Sintering},
journal = {Coatings},
year = {2025},
volume = {15},
number = {12},
pages = {1387},
doi = {10.3390/coatings15121387}
}
EUVIMED