EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Facile Synthesis of Sponge-like Microstructured CuO Anode Material for Rechargeable Lithium-Ion Batteries

W. T. R. S. Fernando, T. H. N. G. Amaraweera, K. M. D. C. Jayathilaka, L. S. R. Kumara, O. Seo, K. Osaka, O. Sakata, R. P. Wijesundera, H. W. M. A. C. Wijayasinghe

Coatings · 15.04.2025 · 15 (4) · 467

DOI: 10.3390/coatings15040467 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Coatings, online erschienen am 15.04.2025. Verfasst von W. T. R. S. Fernando und 8 weiteren Autor:innen. Die Arbeit wurde bisher 11-mal zitiert (Crossref) und nennt 44 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Center for Advanced Battery Research, National Institute of Fundamental Studies, Kandy 20000, Sri Lanka.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

CuO was synthesized by employing the facile chemical precipitation technique to vary the concentrations of Cu(NO3)2 in a range from 0.001 to 0.1 M. This was carried out in order to find the concentration of Cu(NO3)2 that results in optimal electrochemical performance in CuO as an anode electrode material for lithium-ion batteries. Among the investigated concentrations, the 0.03 M Cu(NO3)2 showed the best electrochemical performance. Of the synthesized materials, the scanning electron microscopic (SEM) analysis revealed the existence of a sponge-like morphology. X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), synchrotron X-ray diffraction (SXRD) and Raman spectrum confirmed the formation of a required CuO phase. The electron density distribution on the crystalline structure of the synthesized CuO indicates the existence of the highest distribution of electrons around Cu atoms, with enhanced productivity of the conversion mechanism during the cycling process. Further, this study shows that the electronic interfacial properties of Cu/CuO could be improved by optimizing the amount of acetylene black used for the electrode fabrication, with 20 wt% being the optimum value. The electrodes fabricated with the synthesized sponge-like microstructured CuO as the active material exhibited a high initial specific discharge capacity of 3371.9 mA h g−1 and resulted in a specific discharge capacity of 442.9 mA h g−1 (Coulombic efficiency of 97.4%) after 50 cycles, at a rate of 0.2 C. Moreover, the specific discharge capacity reported at the rate of 1.0 C was 217.6 mA h g−1 with a significantly high Coulombic efficiency of about 98.0% after 50 cycles. Altogether, this study reveals the high potentiality of using sponge-like microstructured CuO as a high-performance anode electrode material for LIBs.

Förderung

  • National Center for Advanced Battery Research, National Institute of Fundamental Studies, Kandy 20000, Sri Lanka

Zitieren

APA

Fernando, W. T. R. S., Amaraweera, T. H. N. G., Jayathilaka, K. M. D. C., Kumara, L. S. R., Seo, O., Osaka, K., Sakata, O., Wijesundera, R. P., & Wijayasinghe, H. W. M. A. C. (2025). Facile Synthesis of Sponge-like Microstructured CuO Anode Material for Rechargeable Lithium-Ion Batteries. Coatings, 15(4), 467. https://doi.org/10.3390/coatings15040467

Vancouver

Fernando WTRS, Amaraweera THNG, Jayathilaka KMDC, Kumara LSR, Seo O, Osaka K, et al. Facile Synthesis of Sponge-like Microstructured CuO Anode Material for Rechargeable Lithium-Ion Batteries. Coatings. 2025;15(4):467. doi:10.3390/coatings15040467

BibTeX
@article{Fernando2025,
  author = {Fernando, W. T. R. S. and Amaraweera, T. H. N. G. and Jayathilaka, K. M. D. C. and Kumara, L. S. R. and Seo, O. and Osaka, K. and Sakata, O. and Wijesundera, R. P. and Wijayasinghe, H. W. M. A. C.},
  title = {Facile Synthesis of Sponge-like Microstructured CuO Anode Material for Rechargeable Lithium-Ion Batteries},
  journal = {Coatings},
  year = {2025},
  volume = {15},
  number = {4},
  pages = {467},
  doi = {10.3390/coatings15040467}
}
Kostenlos starten →