EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Numerical Simulation and Experimental Prediction of the Cladding Layer Based on the Response Surface Method

Ruhai Yan, Zhuang Liu

Coatings · 28.04.2023 · 13 (5) · 845

DOI: 10.3390/coatings13050845 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Coatings, online erschienen am 28.04.2023. Verfasst von Ruhai Yan und 1 weiteren Autor:innen. Die Arbeit wurde bisher 10-mal zitiert (Crossref) und nennt 37 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

To study the surface morphology of laser cladding, Workbench simulated the influence of laser power and scanning speed on the width and height of the cladding layer numerically, as well as the temperature field change and residual stress distribution of the cladding layer. The simulation results reveal that the melting height and width of the cladding layer are inversely proportional to the scanning speed. When the scanning speed is from V = 3 mm/s to V = 5 mm/s, the Al cladding layer’s melting width and melting height are reduced by 15.59% and 20.8%, respectively. A positive correlation exists between the melting height and width of the cladding layer and the laser power. When the laser power changes from P = 23 w to P = 27 w, the welding width and height of the A1 cladding layer increase by 6.55% and 55.56%, respectively. The melting height and width of the second cladding layer are generally higher than those of the bottom cladding layer. The pre-experiment screening process parameters ranges are laser power P (23 w–27 w) and scanning speed (3 mm/s–8 mm/s). Based on the Minitab response surface central composite method, the most notable influence on the melting height and width is revealed to be the powder-feeding rate and laser power, respectively. The response surface analysis method establishes the regression prediction models of melting width and height. The predicted value of melting width was 95.68%, and the predicted value of melting height was 82.26%. The results show that the values of cladding width and height are within the 95% prediction interval, proving that the regression model is correct.

Zitieren

APA

Yan, R., & Liu, Z. (2023). Numerical Simulation and Experimental Prediction of the Cladding Layer Based on the Response Surface Method. Coatings, 13(5), 845. https://doi.org/10.3390/coatings13050845

Vancouver

Yan R, Liu Z. Numerical Simulation and Experimental Prediction of the Cladding Layer Based on the Response Surface Method. Coatings. 2023;13(5):845. doi:10.3390/coatings13050845

BibTeX
@article{Yan2023,
  author = {Yan, Ruhai and Liu, Zhuang},
  title = {Numerical Simulation and Experimental Prediction of the Cladding Layer Based on the Response Surface Method},
  journal = {Coatings},
  year = {2023},
  volume = {13},
  number = {5},
  pages = {845},
  doi = {10.3390/coatings13050845}
}
Kostenlos starten →