EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Dispersion of Carbon Nanotubes Improved by Ball Milling to Prepare Functional Epoxy Nanocomposites

Ziqi Gao, Quanjiabao Han, Jianbang Liu, Kangbo Zhao, Yin Yu, Yuanyuan Feng, Sensen Han

Coatings · 20.03.2023 · 13 (3) · 649

DOI: 10.3390/coatings13030649 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Coatings, online erschienen am 20.03.2023. Verfasst von Ziqi Gao und 6 weiteren Autor:innen. Die Arbeit wurde bisher 25-mal zitiert (Crossref) und nennt 47 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

There has been an increase in interest in developing functional polymer composites based on green chemistry principles. The purpose of this study was to investigate the preparation of functional epoxy/carbon nanotube nanocomposites using ball milling methods. In contrast to mechanical mixing, ball milling promoted good dispersion of CNTs within the epoxy matrix, thereby improving their mechanical properties and electrical conductivity. In epoxy nanocomposites with ball milling, Young’s modulus and tensile strength were increased by 653% and 150%, respectively, when CNT loading was 1.0 vol%. Additionally, the ball milling of CNTs improves their dispersion, resulting in a low percolation threshold at 0.67 vol%. The epoxy/CNT film sensor that was produced using the ball milling approach not only exhibited high reliability and sensitivity to mechanical strains and impact loads, but also possessed the ability to self-detect damage, such as cracks, and accurately locate them. This study marks a notable milestone in the advancement of functional epoxy/CNT composites through the ball milling approach.

Zitieren

APA

Gao, Z., Han, Q., Liu, J., Zhao, K., Yu, Y., Feng, Y., & Han, S. (2023). Dispersion of Carbon Nanotubes Improved by Ball Milling to Prepare Functional Epoxy Nanocomposites. Coatings, 13(3), 649. https://doi.org/10.3390/coatings13030649

Vancouver

Gao Z, Han Q, Liu J, Zhao K, Yu Y, Feng Y, et al. Dispersion of Carbon Nanotubes Improved by Ball Milling to Prepare Functional Epoxy Nanocomposites. Coatings. 2023;13(3):649. doi:10.3390/coatings13030649

BibTeX
@article{Gao2023,
  author = {Gao, Ziqi and Han, Quanjiabao and Liu, Jianbang and Zhao, Kangbo and Yu, Yin and Feng, Yuanyuan and Han, Sensen},
  title = {Dispersion of Carbon Nanotubes Improved by Ball Milling to Prepare Functional Epoxy Nanocomposites},
  journal = {Coatings},
  year = {2023},
  volume = {13},
  number = {3},
  pages = {649},
  doi = {10.3390/coatings13030649}
}
Kostenlos starten →