EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Analysis of Dew-Point Corrosion in Crude Fractionator Overhead Materials Using Advanced Corrosion Monitoring

Hiroki Ishikawa

Corrosion and Materials Degradation · 14.08.2026 · 7 (3) · 51

DOI: 10.3390/cmd7030051 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Corrosion and Materials Degradation, online erschienen am 14.08.2026. Verfasst von Hiroki Ishikawa. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 22 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Severe localized corrosion in crude unit overhead systems is a critical integrity concern, particularly under transient wetting conditions. This study combines high-frequency online ultrasonic (UT) monitoring with a simplified dew-point temperature margin (ΔT) to evaluate short-term changes in corrosion severity during operation. Wall-thickness data obtained at 12 h intervals were used to derive long-term thinning trends and a short-interval corrosion rate indicator (CR12h). CR12h increased as ΔT decreased, indicating that reduced dew-point margin was associated with increased corrosion severity. Although ΔT is not an exact thermodynamic dew-point prediction, it served as a practical operational proxy for transient wet-corrosion propensity. The evaluation supported partial replacement of the affected column-top region with Alloy C-276 cladding. Follow-up inspection after four years showed approximately 0.1 mm of pitting, corresponding to about 0.025 mm/y, which was approximately one order of magnitude lower than the previous Type 405 stainless-steel cladding. These results demonstrate a practical approach for linking continuous corrosion-monitoring data with operational indicators and material-selection decisions in crude unit overhead systems. The study further illustrates how monitoring-derived insights can be translated into repair planning and subsequently validated through long-term field performance following material upgrade.

Zitieren

APA

Ishikawa, H. (2026). Analysis of Dew-Point Corrosion in Crude Fractionator Overhead Materials Using Advanced Corrosion Monitoring. Corrosion and Materials Degradation, 7(3), 51. https://doi.org/10.3390/cmd7030051

Vancouver

Ishikawa H. Analysis of Dew-Point Corrosion in Crude Fractionator Overhead Materials Using Advanced Corrosion Monitoring. Corrosion and Materials Degradation. 2026;7(3):51. doi:10.3390/cmd7030051

BibTeX
@article{Ishikawa2026,
  author = {Ishikawa, Hiroki},
  title = {Analysis of Dew-Point Corrosion in Crude Fractionator Overhead Materials Using Advanced Corrosion Monitoring},
  journal = {Corrosion and Materials Degradation},
  year = {2026},
  volume = {7},
  number = {3},
  pages = {51},
  doi = {10.3390/cmd7030051}
}
Kostenlos starten →