High-Temperature Steam- and CO2-Assisted Gasification of Oil Sludge and Petcoke
Clean Technologies · 14.02.2025 · 7 (1) · 17
DOI: 10.3390/cleantechnol7010017 ↗Kurz gefasst
Fachartikel in der Zeitschrift Clean Technologies, online erschienen am 14.02.2025. Verfasst von Sergey M. Frolov und 13 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 62 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Science and Higher Education of the Russian Federation.
Abstract (Originalsprache)
A new high-temperature allothermal gasification technology is used to process three types of oil waste: ground oil sludge (GOS), tank oil sludge (TOS), and petcoke. The gasifying agent (GA), mainly composed of H2O and CO2 at a temperature above 2300 K and atmospheric pressure, is produced by pulsed detonations of a near-stochiometric methane-oxygen mixture. The gasification experiments show that the dry off-gas contains 80–90 vol.% combustible gas composed of 40–45 vol.% CO, 28–33 vol.% H2, 5–10 vol.% CH4, and 4–7 vol.% noncondensable C2–C3 hydrocarbons. The gasification process is accompanied by the removal of mass from a flow gasifier in the form of fine solid ash particles with a size of about 1 μm. The ash particles have a mesoporous structure with a specific surface area ranging from 3.3 to 15.2 m2/g and pore sizes ranging from 3 to 50 nm. The measured wall temperatures of the gasifier are in reasonable agreement with the calculated value of the thermodynamic equilibrium temperature of the off-gas. The measured CO content in the off-gas is in good agreement with the thermodynamic calculations. The reduced H2 content and elevated contents of CH4, CO2, and CxHy are apparently associated with the nonuniform distribution of the waste/GA mass ratio in the gasifier. To increase the H2 yield, it is necessary to improve the mixing of waste with the GA. It is proposed to mix crushed petcoke with oil sludge to form a paste and feed the combined waste into the gasifier using a specially designed feeder.
Förderung
- Ministry of Science and Higher Education of the Russian Federation
Zitieren
APA
Frolov, S. M., Smetanyuk, V. A., Sadykov, I. A., Silantiev, A. S., Frolov, F. S., Popkova, V. Y., Hasiak, J. K., Buyanovskaya, A. G., Takazova, R. U., Dudareva, T. V., Bekeshev, V. G., Vorobyov, A. B., Inozemtsev, A. V., & Inozemtsev, J. O. (2025). High-Temperature Steam- and CO2-Assisted Gasification of Oil Sludge and Petcoke. Clean Technologies, 7(1), 17. https://doi.org/10.3390/cleantechnol7010017
Vancouver
Frolov SM, Smetanyuk VA, Sadykov IA, Silantiev AS, Frolov FS, Popkova VY, et al. High-Temperature Steam- and CO2-Assisted Gasification of Oil Sludge and Petcoke. Clean Technologies. 2025;7(1):17. doi:10.3390/cleantechnol7010017
BibTeX
@article{Frolov2025,
author = {Frolov, Sergey M. and Smetanyuk, Viktor A. and Sadykov, Ilyas A. and Silantiev, Anton S. and Frolov, Fedor S. and Popkova, Vera Ya. and Hasiak, Jaroslav K. and Buyanovskaya, Anastasiya G. and Takazova, Rina U. and Dudareva, Tatiana V. and Bekeshev, Valentin G. and Vorobyov, Alexey B. and Inozemtsev, Alexey V. and Inozemtsev, Jaroslav O.},
title = {High-Temperature Steam- and CO2-Assisted Gasification of Oil Sludge and Petcoke},
journal = {Clean Technologies},
year = {2025},
volume = {7},
number = {1},
pages = {17},
doi = {10.3390/cleantechnol7010017}
}
EUVIMED