Catalytic Pyrolysis of Polypropylene (PP) as a Way to Gasify Waste Plastic into the Fuel for SOFC
Catalysts · 19.03.2026 · 16 (3) · 275
DOI: 10.3390/catal16030275 ↗Kurz gefasst
Fachartikel in der Zeitschrift Catalysts, online erschienen am 19.03.2026. Verfasst von Michał Dominów und 8 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 28 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Polish National Centre of Research and Development.
Abstract (Originalsprache)
The thermal decomposition (pyrolysis) of polypropylene has been investigated as a viable method for polymer waste recycling and the production of hydrogen-rich fuel. This study examined the effects of atmosphere, temperature, and catalytic systems based on iron oxide and strontium titanate, with a focus on gas-phase composition and reaction dynamics. A reactor geometry conducive to in-bed reforming was utilized, leading to a purer gas output compared to commonly reported results, making it suitable for solid oxide fuel cell (SOFC) applications. The hydrogen concentration was enhanced with increasing temperature, primarily due to the intensified reforming of methane and higher hydrocarbons. However, only marginal improvements were observed between 700 °C and 800 °C, which limits the benefits of higher energy input. The introduction of small amounts of water vapor (approximately 3% relative humidity) resulted in a reduction in solid residue formation by approximately 50% and a slight increase in hydrogen yield. Conversely, CO2 atmospheres suppressed hydrogen production and increased residual solids but allowed for better control over reaction dynamics. The combined strontium titanate iron oxide catalyst (S-STO@FexOγ) demonstrated high efficacy, reducing solid residues to nearly zero and producing gas mixtures containing up to 45% hydrogen. This indicates significant potential for application and further development. These findings underscore the feasibility of in-bed reforming in polypropylene pyrolysis as a waste-to-energy strategy for hydrogen-rich fuel production, warranting further optimization and investigation for SOFC integration.
Förderung
- Polish National Centre of Research and Development
Zitieren
APA
Dominów, M., Zdankiewicz, J., Kujawska, K., Liao, Y., Hsu, Y., Wang, S., Karczewski, J., Bochentyn, B., & Jasiński, P. (2026). Catalytic Pyrolysis of Polypropylene (PP) as a Way to Gasify Waste Plastic into the Fuel for SOFC. Catalysts, 16(3), 275. https://doi.org/10.3390/catal16030275
Vancouver
Dominów M, Zdankiewicz J, Kujawska K, Liao Y, Hsu Y, Wang S, et al. Catalytic Pyrolysis of Polypropylene (PP) as a Way to Gasify Waste Plastic into the Fuel for SOFC. Catalysts. 2026;16(3):275. doi:10.3390/catal16030275
BibTeX
@article{Dominw2026,
author = {Dominów, Michał and Zdankiewicz, Jakub and Kujawska, Kinga and Liao, Yi-Le and Hsu, Yuan-Fu and Wang, Sea-Fue and Karczewski, Jakub and Bochentyn, Beata and Jasiński, Piotr},
title = {Catalytic Pyrolysis of Polypropylene (PP) as a Way to Gasify Waste Plastic into the Fuel for SOFC},
journal = {Catalysts},
year = {2026},
volume = {16},
number = {3},
pages = {275},
doi = {10.3390/catal16030275}
}
EUVIMED