3D Laser Scanning-Based Automated Wall Surface Flatness Inspection
Buildings · 22.07.2026 · 16 (14) · 2911
DOI: 10.3390/buildings16142911 ↗Kurz gefasst
Fachartikel in der Zeitschrift Buildings, online erschienen am 22.07.2026. Verfasst von Haile Shuai und 6 weiteren Autor:innen. Die Arbeit nennt 30 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Scientific Research Project of China Construction Fourth Engineering Division Corp. Ltd., Guizhou Provincial Science and Technology Support Program, Scientific Research Project of China State Construction Engineering Corporation Limited.
Abstract (Originalsprache)
Indoor wall surface flatness is a mandatory acceptance item in building decoration work, but it is still commonly checked using a 2 m straightedge and a feeler gauge. This manual method samples only a limited number of locations, depends on inspector judgement, and provides no full-surface spatial record. This study proposes a terrestrial laser scanning (TLS)-based automated workflow for wall surface flatness inspection that remains consistent with the Chinese national standard GB 50210-2018. After point-cloud registration and wall segmentation, a least-squares best-fit plane is established for each wall, and the signed point-to-plane deviation field is computed. A virtual 2 m straightedge operator is then applied at multiple positions and orientations to reproduce the code-defined measurement in which the maximum gap under the straightedge is taken as the flatness reading. The method was validated against paired manual measurements on a reference wall, showing a mean difference of 0.00 mm, a standard deviation of 0.20 mm, an RMSE of 0.20 mm, and a correlation coefficient of 0.98, with identical accept/reject decisions at the 4 mm limit. A residential case study involving four inspection zones and 42 measurement points further demonstrated that the workflow can generate code-comparable flatness readings, full-surface deviation maps, and localized rework guidance. The overall pass rate was 92.9%, with all non-conforming points concentrated in the living room, and the on-site inspection time was approximately halved compared to manual checking. The results indicate that the proposed TLS-based virtual-straightedge method provides a practical, traceable, and standard-compliant alternative for automated wall surface flatness acceptance.
Förderung
- Scientific Research Project of China Construction Fourth Engineering Division Corp. Ltd.
- Guizhou Provincial Science and Technology Support Program
- Scientific Research Project of China State Construction Engineering Corporation Limited
Zitieren
APA
Shuai, H., Chi, H., Li, Y., Wang, Y., Qian, Y., Lai, Z., & Wang, Y. (2026). 3D Laser Scanning-Based Automated Wall Surface Flatness Inspection. Buildings, 16(14), 2911. https://doi.org/10.3390/buildings16142911
Vancouver
Shuai H, Chi H, Li Y, Wang Y, Qian Y, Lai Z, et al. 3D Laser Scanning-Based Automated Wall Surface Flatness Inspection. Buildings. 2026;16(14):2911. doi:10.3390/buildings16142911
BibTeX
@article{Shuai2026,
author = {Shuai, Haile and Chi, Huihai and Li, Yujiang and Wang, Yuanqing and Qian, Yachao and Lai, Zhenbin and Wang, Yansong},
title = {3D Laser Scanning-Based Automated Wall Surface Flatness Inspection},
journal = {Buildings},
year = {2026},
volume = {16},
number = {14},
pages = {2911},
doi = {10.3390/buildings16142911}
}
EUVIMED