Load-Dependent Non-Uniform Bending Stiffness and Curvature-Based Deflection Calculation in Timber–Concrete Composite Beams
Buildings · 03.03.2026 · 16 (5) · 989
DOI: 10.3390/buildings16050989 ↗Kurz gefasst
Fachartikel in der Zeitschrift Buildings, online erschienen am 03.03.2026. Verfasst von Yuchen Jiang und 1 weiteren Autor:innen. Die Arbeit nennt 28 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Natural Science Research of Jiangsu Higher Education Institutions of China, Qinglan Project of Jiangsu Province of China.
Abstract (Originalsprache)
The effective bending stiffness formula for cross-sections of timber–concrete composite (TCC) beams was derived under semi-sinusoidal loading condition in Eurocode 5; however, this formula does not account for the non-uniform distribution of bending stiffness along the span. This limitation prevents it from characterizing the mechanical behavior under real loading conditions, which could potentially compromise the safety and serviceability of the structural design. To investigate the distribution pattern of bending stiffness, differential segment analysis was conducted, incorporating interfacial slip effects. A governing differential equation for curvature was established, and the resulting curvature distribution was used to compute deflections by means of the conjugate beam method. The results demonstrate that the bending stiffness distribution depends critically on shear connector arrangement and loading conditions. Under third-point loading, the bending stiffness monotonically decreases from the mid-span to the load application points and increases toward the supports. Under uniform loads, bending stiffness peaks at the mid-span and declines gradually toward the supports. Reducing shear connector spacing enhances composite action while amplifying bending stiffness non-uniformity. Experimental validation confirms that both the conjugate beam method (using analytical curvature solutions) and the simplified approach in Eurocode 5 achieve 99% average accuracy in predicting the mid-span deflection of TCC beams. In addition, careful attention must be paid to the deflection values at loading points, particularly when the loading position is close to the supports.
Förderung
- Natural Science Research of Jiangsu Higher Education Institutions of China
- Qinglan Project of Jiangsu Province of China
Zitieren
APA
Jiang, Y., & Hu, X. (2026). Load-Dependent Non-Uniform Bending Stiffness and Curvature-Based Deflection Calculation in Timber–Concrete Composite Beams. Buildings, 16(5), 989. https://doi.org/10.3390/buildings16050989
Vancouver
Jiang Y, Hu X. Load-Dependent Non-Uniform Bending Stiffness and Curvature-Based Deflection Calculation in Timber–Concrete Composite Beams. Buildings. 2026;16(5):989. doi:10.3390/buildings16050989
BibTeX
@article{Jiang2026,
author = {Jiang, Yuchen and Hu, Xiamin},
title = {Load-Dependent Non-Uniform Bending Stiffness and Curvature-Based Deflection Calculation in Timber–Concrete Composite Beams},
journal = {Buildings},
year = {2026},
volume = {16},
number = {5},
pages = {989},
doi = {10.3390/buildings16050989}
}
EUVIMED