EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

The Mechanical Properties and Microstructural Characterization of Copper Tailing Backfill Cemented with a Slag-Based Material

Haina Zhang, Xiutao Zhang, Lingsheng Yan, Changsheng Xie, Zewen Zhu, Shunman Chen, Xinyue Jiang

Buildings · 06.11.2025 · 15 (21) · 4004

DOI: 10.3390/buildings15214004 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Buildings, online erschienen am 06.11.2025. Verfasst von Haina Zhang und 6 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 47 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China, the Open Fund of Key Laboratory of Road Structure and Material of the Ministry of Transport, the Project Supported by Jiangxi Provincial Natural Science Foundation.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

To address the challenges associated with Ordinary Portland Cement (OPC) in mine backfilling, including high costs, the large carbon footprint, and performance limitations, a novel cementitious powder (CP) based on alkali-activated slag is developed in this work. The mechanical performance and microstructural strengthening mechanism of this CP as a substitute for OPC in cemented copper tailing backfill (CTB) were systematically evaluated. The effects of key parameters, including the solid content (SC), tailing-to-cement ratio (TCR), and curing age (CA), were investigated using uniaxial compressive strength (UCS) tests and scanning electron microscopy (SEM) analysis. The results demonstrate that the novel binder exhibits superior performance. At a solid content of 73%, the CTB prepared with CP at a TCR of 10 or 12 achieved a compressive strength comparable to or exceeding that of the OPC-based counterpart with a TCR of 8. This represents a 33% reduction in binder dosage without sacrificing performance. The UCS of the CTB increased significantly with a decreasing TCR and an increasing CA, with the most rapid strength development observed during the early curing stages (≤7 days). The stress–strain behavior transitioned from plastic yielding to strain-softening with prolonged curing, and the macroscopic failure was predominantly governed by tensile cracking. Microstructural analysis revealed that the strength development of the CTB originates from the continuous formation of hydration products, such as calcium-silicate-hydrate (C-S-H) gel and ettringite. These products progressively fill pores and encapsulate tailing particles, creating a dense and interlocking skeletal structure. A lower TCR and a longer CA promote the formation of a more integrated and compact micro-network, thereby enhancing the macroscopic mechanical strength. This study confirms the viability of the slag-based binder as a sustainable alternative to OPC in mining backfill applications, providing a critical theoretical basis and technical support for the low-cost, eco-friendly utilization of mining solid waste.

Förderung

  • National Natural Science Foundation of China
  • the Open Fund of Key Laboratory of Road Structure and Material of the Ministry of Transport
  • the Project Supported by Jiangxi Provincial Natural Science Foundation
  • East China Jiaotong University scientific research fund

Zitieren

APA

Zhang, H., Zhang, X., Yan, L., Xie, C., Zhu, Z., Chen, S., & Jiang, X. (2025). The Mechanical Properties and Microstructural Characterization of Copper Tailing Backfill Cemented with a Slag-Based Material. Buildings, 15(21), 4004. https://doi.org/10.3390/buildings15214004

Vancouver

Zhang H, Zhang X, Yan L, Xie C, Zhu Z, Chen S, et al. The Mechanical Properties and Microstructural Characterization of Copper Tailing Backfill Cemented with a Slag-Based Material. Buildings. 2025;15(21):4004. doi:10.3390/buildings15214004

BibTeX
@article{Zhang2025,
  author = {Zhang, Haina and Zhang, Xiutao and Yan, Lingsheng and Xie, Changsheng and Zhu, Zewen and Chen, Shunman and Jiang, Xinyue},
  title = {The Mechanical Properties and Microstructural Characterization of Copper Tailing Backfill Cemented with a Slag-Based Material},
  journal = {Buildings},
  year = {2025},
  volume = {15},
  number = {21},
  pages = {4004},
  doi = {10.3390/buildings15214004}
}
Kostenlos starten →