Research on Vehicle Fatigue Load Spectrum of Highway Bridges Based on Weigh-in-Motion Data
Buildings · 21.02.2025 · 15 (5) · 675
DOI: 10.3390/buildings15050675 ↗Kurz gefasst
Fachartikel in der Zeitschrift Buildings, online erschienen am 21.02.2025. Verfasst von Ruisheng Feng und 5 weiteren Autor:innen. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 27 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Chongqing Natural Science Foundation of China, State Key Laboratory of Structural Dynamics of Bridge Engineering and Key Laboratory of Bridge Structure Seismic Technology for Transportation Industry Open Fu…, Open Fund of State Key Laboratory of the Mountain Bridge and Tunnel Engineering.
Abstract (Originalsprache)
Establishing an accurate vehicle fatigue load spectrum is a critical prerequisite for fatigue life analysis and design of highway bridges. However, the time-varying and regional characteristics of vehicle loads pose significant challenges to achieving this goal. This study focuses on vehicle data collected by a weigh-in-motion system installed on a highway bridge in Chongqing, China. The statistical characteristics of vehicle-load-related parameters are analyzed, and the actual vehicle fatigue load spectrum for this section of the road is established. Specifically, vehicles are first categorized based on axle count characteristics. Then, statistical analyses are conducted on key parameters such as vehicle weight, headway time, and axle load for each vehicle type. Finally, the actual vehicle fatigue load spectrum is developed based on Miner’s linear damage rule and the equivalent fatigue damage principle, and the contributions of different vehicle types to fatigue damage are investigated. The results show that the weight distributions of different vehicle types follow a Gaussian mixture distribution, while the headway time distribution for each lane follows a log-normal distribution. A linear approximate relationship was observed between the axle loads of different vehicle types and their respective total weights. Although two-axle trucks exhibited higher frequencies, six-axle trucks contributed the most to structural fatigue damage, accounting for 53.81%. Therefore, six-axle trucks can be regarded as the standard fatigue vehicle model for this section of the road. These findings provide valuable insights for fatigue design and fatigue life assessment of highway bridges under similar vehicle loading conditions.
Förderung
- Chongqing Natural Science Foundation of China
- State Key Laboratory of Structural Dynamics of Bridge Engineering and Key Laboratory of Bridge Structure Seismic Technology for Transportation Industry Open Fu…
- Open Fund of State Key Laboratory of the Mountain Bridge and Tunnel Engineering
Zitieren
APA
Feng, R., Xie, G., Zhang, Y., Kong, H., Wu, C., & Liu, H. (2025). Research on Vehicle Fatigue Load Spectrum of Highway Bridges Based on Weigh-in-Motion Data. Buildings, 15(5), 675. https://doi.org/10.3390/buildings15050675
Vancouver
Feng R, Xie G, Zhang Y, Kong H, Wu C, Liu H. Research on Vehicle Fatigue Load Spectrum of Highway Bridges Based on Weigh-in-Motion Data. Buildings. 2025;15(5):675. doi:10.3390/buildings15050675
BibTeX
@article{Feng2025,
author = {Feng, Ruisheng and Xie, Guilin and Zhang, Youjia and Kong, Hu and Wu, Chao and Liu, Haiming},
title = {Research on Vehicle Fatigue Load Spectrum of Highway Bridges Based on Weigh-in-Motion Data},
journal = {Buildings},
year = {2025},
volume = {15},
number = {5},
pages = {675},
doi = {10.3390/buildings15050675}
}
EUVIMED