EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Rubberized Concrete: Effect of the Rubber Size and Content on Static and Dynamic Behavior

Tianyang Du, Yue Yang, Huidong Cao, Nan Si, Hadi Kordestani, Zhwan Dilshad Ibrahim Sktani, Ali Arab, Chunwei Zhang

Buildings · 26.05.2024 · 14 (6) · 1541

DOI: 10.3390/buildings14061541 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Buildings, online erschienen am 26.05.2024. Verfasst von Tianyang Du und 7 weiteren Autor:innen. Die Arbeit wurde bisher 30-mal zitiert (Crossref) und nennt 76 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China, Ministry of Science and Technology of China, Department of Science and Technology of Shandong Province.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Rubberized concrete (RC) has received widespread attention due to its energy absorption and crack resistance properties. However, due to its low compressive strength, it is not recommended for structural applications. The rubber size and content affect RC’s mechanical properties. This study investigated and formulated the behavior of RC with different particle sizes and contents under dynamic and static loading. Quasi-static compressive and dynamic tests were conducted on RC with varying content of rubber (0–30%) and rubber sizes (0.1–20 mm). It was found that the rubber particle size was 0.5mm and the rubber content was 2%. An equation was derived from the experimental data to forecast the impact of rubber size and content on compressive strength. Additionally, by combining the literature and this research’s data, a model was established based on neural networks to predict the strength of RC. SHPB tests were carried out to study the stress–strain curves under dynamic load. The peak stress, fragment analysis, and energy absorption of RC with varying content of rubber and rubber sizes at three different strain rates (100 s−1, 160 s−1, and 290 s−1) were investigated. Equations describing the relationship between dynamic increase factor (DIF), rubber material content, and strain rate on different particle sizes were obtained by fitting. The DIF increased as the content of the rubber increased. By analyzing energy absorption data, it was found that the optimal ratio for energy absorption was RC-0.5-30, RC-0.1-30, and RC-10-30 at strain rates of 100 s−1, 160 s−1, and 290 s−1. This study could be a good guideline for other researchers to easily select the content and size of the rubber in RC for their applications. It also has a positive significance in promoting the development of green building materials.

Förderung

  • National Natural Science Foundation of China
  • Ministry of Science and Technology of China
  • Department of Science and Technology of Shandong Province

Zitieren

APA

Du, T., Yang, Y., Cao, H., Si, N., Kordestani, H., Sktani, Z. D. I., Arab, A., & Zhang, C. (2024). Rubberized Concrete: Effect of the Rubber Size and Content on Static and Dynamic Behavior. Buildings, 14(6), 1541. https://doi.org/10.3390/buildings14061541

Vancouver

Du T, Yang Y, Cao H, Si N, Kordestani H, Sktani ZDI, et al. Rubberized Concrete: Effect of the Rubber Size and Content on Static and Dynamic Behavior. Buildings. 2024;14(6):1541. doi:10.3390/buildings14061541

BibTeX
@article{Du2024,
  author = {Du, Tianyang and Yang, Yue and Cao, Huidong and Si, Nan and Kordestani, Hadi and Sktani, Zhwan Dilshad Ibrahim and Arab, Ali and Zhang, Chunwei},
  title = {Rubberized Concrete: Effect of the Rubber Size and Content on Static and Dynamic Behavior},
  journal = {Buildings},
  year = {2024},
  volume = {14},
  number = {6},
  pages = {1541},
  doi = {10.3390/buildings14061541}
}
Kostenlos starten →