EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Design for Manufacture and Assembly of Digital Fabrication and Additive Manufacturing in Construction: A Review

Wiput Tuvayanond, Lapyote Prasittisopin

Buildings · 03.02.2023 · 13 (2) · 429

DOI: 10.3390/buildings13020429 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Buildings, online erschienen am 03.02.2023. Verfasst von Wiput Tuvayanond und 1 weiteren Autor:innen. Die Arbeit wurde bisher 65-mal zitiert (Crossref) und nennt 171 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Multidisciplinary Research Grant, Faculty of Architecture, Chulalongkorn University, Thailand Science Research and Innovation Fund, Chulalongkorn University.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Design for manufacture and assembly (DfMA) in the architectural, engineering, and construction (AEC) industry is attracting the attention of designers, practitioners, and construction project stakeholders. Digital fabrication (Dfab) and design for additive manufacturing (DfAM) practices are found in current need of further research and development. The DfMA’s conceptual function is to maximize the process efficiency of Dfab and AM building projects. This work reviewed 171 relevant research articles over the past few decades. The concepts and the fundamentals of DfMA in building and construction were explored. In addition, DfMA procedures for Dfab, DfAM, and AM assembly processes were discussed. Lastly, the current machine learning research on DfMA in construction was also highlighted. As Dfab and DFAM are innovated, practical DFMA techniques begin to develop to a great extent. Large research gaps in the DfMA for Dfab and DfAM can be filled in terms of integrating them with product structural performance, management, studied cases, building information modeling (BIM), and machine learning to increase operational efficiency and sustainable practices.

Förderung

  • Multidisciplinary Research Grant, Faculty of Architecture, Chulalongkorn University
  • Thailand Science Research and Innovation Fund, Chulalongkorn University

Zitieren

APA

Tuvayanond, W., & Prasittisopin, L. (2023). Design for Manufacture and Assembly of Digital Fabrication and Additive Manufacturing in Construction: A Review. Buildings, 13(2), 429. https://doi.org/10.3390/buildings13020429

Vancouver

Tuvayanond W, Prasittisopin L. Design for Manufacture and Assembly of Digital Fabrication and Additive Manufacturing in Construction: A Review. Buildings. 2023;13(2):429. doi:10.3390/buildings13020429

BibTeX
@article{Tuvayanond2023,
  author = {Tuvayanond, Wiput and Prasittisopin, Lapyote},
  title = {Design for Manufacture and Assembly of Digital Fabrication and Additive Manufacturing in Construction: A Review},
  journal = {Buildings},
  year = {2023},
  volume = {13},
  number = {2},
  pages = {429},
  doi = {10.3390/buildings13020429}
}
Kostenlos starten →