Two-in-One Hybrid Sensor Based on PV4D4/AgAu/TiO2 Structure for Carbon Dioxide and Hydrogen Gas Detection in Biomedical and Industrial Fields
Biosensors · 22.12.2025 · 16 (1) · 5
DOI: 10.3390/bios16010005 ↗Kurz gefasst
Fachartikel in der Zeitschrift Biosensors, online erschienen am 22.12.2025. Verfasst von Mihai Brinza und 9 weiteren Autor:innen. Beteiligte Einrichtung: Center for Nanotechnology and Nanosensors, Department of Microelectronics and Biomedical Engineering, Technical University of Moldova, 168 Stefan cel…. Hauptthemen laut MEDLINE: Carbon Dioxide, Hydrogen, Biosensing Techniques. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 91 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Agenția Națională pentru Cercetare și Dezvoltare, National AGENCY FOR RESEARCH AND DEVELOPMENT.
Abstract (Originalsprache)
A novel two-in-one sensor for both carbon dioxide and hydrogen detection has been obtained based on a hybrid heterostructure. It consists of a 30 nm thick TiO2 nanocrystalline film grown by atomic layer deposition (ALD), thermally annealed at 610 °C, and subsequently coated with bimetallic AgAu nanoparticles and covered with a PV4D4 nanolayer, which was thermally treated at 430 °C. Two types of gas response behaviors have been registered, as n-type for hydrogen gas and p-type semiconductor behavior for carbon dioxide gas detection. The highest response for carbon dioxide has been registered at an operating temperature of 150 °C with a value of 130%, while the highest response for hydrogen gas was registered at 350 °C with a value of 230%, although it also attained a relatively good gas selectivity at 150 °C. It is considered that a thermal annealing temperature of 610 °C is better for the properties of TiO2 nanofilms, since it enhances gas sensor sensitivity too. Polymer coating on top is also believed to contribute to a higher influence on selectivity of the sensor structure. Accordingly, to our previous research where PV4D4 has been annealed at 450 °C, in this research paper, a lower temperature of 430 °C for annealing has been used, and thus another ratio of cyclocages and cyclorings has been obtained. Knowing that the polymer acts like a sieve atop the sensor structure, in this study it offers increased selectivity and sensitivity towards carbon dioxide gas detection, as well as maintaining a relatively increased selectivity for hydrogen gas detection, which works as expected with Ag and Au bimetallic nanoparticles on the surface of the sensing structure. The results obtained are highly important for biomedical and environmental applications, as well as for further development of the sensor industry, considering the high potential of two-in-one sensors. A carbon dioxide detector could be used for assessing respiratory markers in patients and monitoring the quality of the environment, while hydrogen could be used for both monitoring lactose intolerance and concentrations in cases of therapeutic gas, as well as monitoring the safe handling of various concentrations.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- Center for Nanotechnology and Nanosensors, Department of Microelectronics and Biomedical Engineering, Technical University of Moldova, 168 Stefan cel Mare Av., MD-2004 Chisinau, Moldova.
- Department of Materials Science, Chair for Multicomponent Materials, Kiel University, Kaiserstraße 2, D-24143 Kiel, Germany.
- Chair for Composite Materials, Faculty of Engineering, Kiel University, Kaiserstraße 2, D-24143 Kiel, Germany.
- Leibniz Institute for Plasma Science and Technology, Felix-Hausdorff-Str. 2, 17489 Greifswald, Germany.
- Functional Nanomaterials, Faculty of Engineering, Institute for Materials Science, Kiel University, Kaiserstra2, 24143 Kiel, Germany.
ORCID-Profile: Mihai Brinza, Lynn Schwäke, Stefan Schröder, Cristian Lupan, Nicolai Ababii, Nicolae Magariu, Maxim Chiriac, Franz Faupel, Oleg Lupan
Förderung
- Agenția Națională pentru Cercetare și Dezvoltare
- National AGENCY FOR RESEARCH AND DEVELOPMENT
Zitieren
APA
Brinza, M., Schwäke, L., Schröder, S., Lupan, C., Ababii, N., Magariu, N., Chiriac, M., Faupel, F., Vahl, A., & Lupan, O. (2025). Two-in-One Hybrid Sensor Based on PV4D4/AgAu/TiO2 Structure for Carbon Dioxide and Hydrogen Gas Detection in Biomedical and Industrial Fields. Biosensors, 16(1), 5. https://doi.org/10.3390/bios16010005
Vancouver
Brinza M, Schwäke L, Schröder S, Lupan C, Ababii N, Magariu N, et al. Two-in-One Hybrid Sensor Based on PV4D4/AgAu/TiO2 Structure for Carbon Dioxide and Hydrogen Gas Detection in Biomedical and Industrial Fields. Biosensors. 2025;16(1):5. doi:10.3390/bios16010005
BibTeX
@article{Brinza2025,
author = {Brinza, Mihai and Schwäke, Lynn and Schröder, Stefan and Lupan, Cristian and Ababii, Nicolai and Magariu, Nicolae and Chiriac, Maxim and Faupel, Franz and Vahl, Alexander and Lupan, Oleg},
title = {Two-in-One Hybrid Sensor Based on PV4D4/AgAu/TiO2 Structure for Carbon Dioxide and Hydrogen Gas Detection in Biomedical and Industrial Fields},
journal = {Biosensors},
year = {2025},
volume = {16},
number = {1},
pages = {5},
doi = {10.3390/bios16010005}
}
EUVIMED