Development of a Redox-Polymer-Based Electrochemical Glucose Biosensor Suitable for Integration in Microfluidic 3D Cell Culture Systems
Biosensors · 2023
DOI: 10.3390/bios13060582 ↗Kurz gefasst
Fachartikel in der Zeitschrift Biosensors, 2023. Verfasst von L Navarro-Nateras und 9 weiteren Autor:innen. Beteiligte Einrichtung: Centro de Investigación y Desarrollo Tecnológico en Electroquímica, Pedro Escobedo 76703, Querétaro, Mexico. Hauptthemen laut MEDLINE: Glucose, Biosensing Techniques. Die Arbeit wurde bisher 16-mal zitiert (Crossref) und nennt 67 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Center of Research and Technologic Development in Electrochemistry, CIDETEQ.
Abstract (Originalsprache)
The inclusion of online, in situ biosensors in microfluidic cell cultures is important to monitor and characterize a physiologically mimicking environment. This work presents the performance of second-generation electrochemical enzymatic biosensors to detect glucose in cell culture media. Glutaraldehyde and ethylene glycol diglycidyl ether (EGDGE) were tested as cross-linkers to immobilize glucose oxidase and an osmium-modified redox polymer on the surface of carbon electrodes. Tests employing screen printed electrodes showed adequate performance in a Roswell Park Memorial Institute (RPMI-1640) media spiked with fetal bovine serum (FBS). Comparable first-generation sensors were shown to be heavily affected by complex biological media. This difference is explained in terms of the respective charge transfer mechanisms. Under the tested conditions, electron hopping between Os redox centers was less vulnerable than H2O2 diffusion to biofouling by the substances present in the cell culture matrix. By employing pencil leads as electrodes, the incorporation of these electrodes in a polydimethylsiloxane (PDMS) microfluidic channel was achieved simply and at a low cost. Under flow conditions, electrodes fabricated using EGDGE presented the best performance with a limit of detection of 0.5 mM, a linear range up to 10 mM, and a sensitivity of 4.69 μA mM−1 cm−2.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- Centro de Investigación y Desarrollo Tecnológico en Electroquímica, Pedro Escobedo 76703, Querétaro, Mexico.
- Instituto de Química Física de los Materiales, Medio Ambiente y Energía, CONICET-Departamento de Química Inorgánica, Analítica y Química Física, Facultad de Ciencias Exactas y Naturales, Universidad de Buenos Aires, Bue…
- Departamento de Medicina Genómica y Toxicología Ambiental, Instituto de Investigaciones Biomédicas, Universidad Nacional Autónoma de México, Ciudad de México 04510, Mexico.
- Unidad de Bioquímica, Instituto Nacional de Ciencias Médicas y Nutrición Salvador Zubirán, Ciudad de México 14080, Mexico.
ORCID-Profile: Jancarlo Diaz-Gonzalez, Lucy L Coria-Oriundo, Fernando Battaglini, Goldie Oza, Jannu R Casanova-Moreno
Förderung
- Center of Research and Technologic Development in Electrochemistry
- CIDETEQ
Zitieren
APA
Navarro-Nateras, L., Diaz-Gonzalez, J., Aguas-Chantes, D., Coria-Oriundo, L. L., Battaglini, F., Ventura-Gallegos, J. L., Zentella-Dehesa, A., Oza, G., Arriaga, L. G., & Casanova-Moreno, J. R. (2023). Development of a Redox-Polymer-Based Electrochemical Glucose Biosensor Suitable for Integration in Microfluidic 3D Cell Culture Systems. Biosensors. https://doi.org/10.3390/bios13060582
Vancouver
Navarro-Nateras L, Diaz-Gonzalez J, Aguas-Chantes D, Coria-Oriundo LL, Battaglini F, Ventura-Gallegos JL, et al. Development of a Redox-Polymer-Based Electrochemical Glucose Biosensor Suitable for Integration in Microfluidic 3D Cell Culture Systems. Biosensors. 2023. doi:10.3390/bios13060582
BibTeX
@article{NavarroNateras2023,
author = {Navarro-Nateras, L and Diaz-Gonzalez, Jancarlo and Aguas-Chantes, Diana and Coria-Oriundo, Lucy L and Battaglini, Fernando and Ventura-Gallegos, José Luis and Zentella-Dehesa, Alejandro and Oza, Goldie and Arriaga, L G and Casanova-Moreno, Jannu R},
title = {Development of a Redox-Polymer-Based Electrochemical Glucose Biosensor Suitable for Integration in Microfluidic 3D Cell Culture Systems},
journal = {Biosensors},
year = {2023},
doi = {10.3390/bios13060582}
}
EUVIMED