EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Considering the Value of 3D Cultures for Enhancing the Understanding of Adhesion, Proliferation, and Osteogenesis on Titanium Dental Implants

Federico Ferro iD, Federico Azzolin, Renza Spelat iD, Lorenzo Bevilacqua iD, Michele Maglione iD

Biomolecules · 2023

DOI: 10.3390/biom13071048 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Biomolecules, 2023. Verfasst von Federico Ferro und 4 weiteren Autor:innen. Beteiligte Einrichtung: Department of Medical and Biological Sciences, University of Udine, 33100 Udine, Italy. Hauptthemen laut MEDLINE: Osteogenesis, Dental Implants. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 60 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: authors’ institution’s.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Background

Individuals with pathologic conditions and restorative deficiencies might benefit from a combinatorial approach encompassing stem cells and dental implants; however, due to the various surface textures and coatings, the influence of titanium dental implants on cells exhibits extensive, wide variations. Three-dimensional (3D) cultures of stem cells on whole dental implants are superior in testing implant properties and were used to examine their capabilities thoroughly. Materials and methods: The surface micro-topography of five titanium dental implants manufactured by sandblasting with titanium, aluminum, corundum, or laser sintered and laser machined was compared in this study. After characterization, including particle size distribution and roughness, the adhesion, proliferation, and viability of adipose-derived stem cells (ADSCs) cultured on the whole-body implants were tested at three time points (one to seven days). Finally, the capacity of the implant to induce ADSCs’ spontaneous osteoblastic differentiation was examined at the same time points, assessing the gene expression of collagen type 1 (coll-I), osteonectin (osn), alkaline phosphatase (alp), and osteocalcin (osc).

Results

Laser-treated (Laser Mach and Laser Sint) implants exhibited the highest adhesion degree; however, limited proliferation was observed, except for Laser Sint implants, while viability differences were seen throughout the three time points, except for Ti Blast implants. Sandblasted surfaces (Al Blast, Cor Blast, and Ti Blast) outpaced the laser-treated ones, inducing higher amounts of coll-I, osn, and alp, but not osc. Among the sandblasted surfaces, Ti Blast showed moderate roughness and the highest superficial texture density, favoring the most significant spontaneous differentiation relative to all the other implant surfaces.

Conclusions

The results indicate that 3D cultures of stem cells on whole-body titanium dental implants is a practical and physiologically appropriate way to test the biological characteristics of the implants, revealing peculiar differences in ADSCs’ adhesion, proliferation, and activity toward osteogenic commitment in the absence of specific osteoinductive cues. In addition, the 3D method would allow researchers to test various implant surfaces more thoroughly. Integrating with preconditioned stem cells would inspire a more substantial combinatorial approach to promote a quicker recovery for patients with restorative impairments.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

OsteogenesisDental ImplantsHumansTitaniumOsteoblastsCell ProliferationSurface PropertiesOsteocalcinCell DifferentiationCell Adhesion

Stichwörter der Autor:innen

cell–surface interactionscombinatorial approachimplantologysurface micro-topographythree-dimensional cell culture

Substanzen

TitaniumDental ImplantsOsteocalcin

Autor:innen und Institutionen

  • Department of Medical and Biological Sciences, University of Udine, 33100 Udine, Italy.
  • Department of Medical, Surgery and Health Sciences, University of Trieste, 34125 Trieste, Italy.
  • Neurobiology Sector, International School for Advanced Studies (SISSA), 34136 Trieste, Italy.

ORCID-Profile: Federico Ferro, Renza Spelat, Lorenzo Bevilacqua, Michele Maglione

Förderung

  • authors’ institution’s

Zitieren

APA

Ferro, F., Azzolin, F., Spelat, R., Bevilacqua, L., & Maglione, M. (2023). Considering the Value of 3D Cultures for Enhancing the Understanding of Adhesion, Proliferation, and Osteogenesis on Titanium Dental Implants. Biomolecules. https://doi.org/10.3390/biom13071048

Vancouver

Ferro F, Azzolin F, Spelat R, Bevilacqua L, Maglione M. Considering the Value of 3D Cultures for Enhancing the Understanding of Adhesion, Proliferation, and Osteogenesis on Titanium Dental Implants. Biomolecules. 2023. doi:10.3390/biom13071048

BibTeX
@article{Ferro2023,
  author = {Ferro, Federico and Azzolin, Federico and Spelat, Renza and Bevilacqua, Lorenzo and Maglione, Michele},
  title = {Considering the Value of 3D Cultures for Enhancing the Understanding of Adhesion, Proliferation, and Osteogenesis on Titanium Dental Implants},
  journal = {Biomolecules},
  year = {2023},
  doi = {10.3390/biom13071048}
}
Kostenlos starten →