EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Lightweight Aircraft Battery Enclosures Made From 3-D Printed Continuous Fiber-Reinforced Composites

Meelad Ranaiefar, Amjad Almansour, Mrityunjay Singh

Batteries · 18.11.2026 · 12 (11) · 497

DOI: 10.3390/batteries12110497 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Batteries, online erschienen am 18.11.2026. Verfasst von Meelad Ranaiefar und 2 weiteren Autor:innen. Die Arbeit nennt 31 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: the NASA Transformational Tools and Technologies (TTT) project under the Battery Thermal Management Project and the Integrated Methods and Research (IMR) Proje…, the Aeronautics Flight Accelerator initiative.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Advanced electric and hybrid-electric aircraft require battery enclosures that are both lightweight and structurally reliable. Continuous fiber-reinforced composites produced via additive manufacturing (AM) offer an effective solution by enabling tailored fiber architectures and reduced mass compared to traditional metallic housings. Continuous fiberglass reinforced (CFGR) composites were fabricated using fused filament fabrication and evaluated under tension, compression, and flexural loading to quantify mechanical performance. A full-scale, 12-inch-long battery enclosure was simulated, optimized, fabricated, and subjected to 100 h of cyclic cantilever bending to assess durability under representative service conditions. Results indicate that fiber orientation and architecture strongly influence mechanical response, with on-edge and concentric configurations exhibiting the highest strength and stiffness. The enclosure sustained repeated deflections of up to 7.65 mm without permanent deformation or cracking, confirming its suitability for installation in aircraft wing structures. These findings demonstrate the potential of continuous fiber AM to produce lightweight, structurally robust battery enclosures and establish a framework for integrating simulation-guided design with mechanical testing.

Förderung

  • the NASA Transformational Tools and Technologies (TTT) project under the Battery Thermal Management Project and the Integrated Methods and Research (IMR) Proje…
  • the Aeronautics Flight Accelerator initiative

Zitieren

APA

Ranaiefar, M., Almansour, A., & Singh, M. (2026). Lightweight Aircraft Battery Enclosures Made From 3-D Printed Continuous Fiber-Reinforced Composites. Batteries, 12(11), 497. https://doi.org/10.3390/batteries12110497

Vancouver

Ranaiefar M, Almansour A, Singh M. Lightweight Aircraft Battery Enclosures Made From 3-D Printed Continuous Fiber-Reinforced Composites. Batteries. 2026;12(11):497. doi:10.3390/batteries12110497

BibTeX
@article{Ranaiefar2026,
  author = {Ranaiefar, Meelad and Almansour, Amjad and Singh, Mrityunjay},
  title = {Lightweight Aircraft Battery Enclosures Made From 3-D Printed Continuous Fiber-Reinforced Composites},
  journal = {Batteries},
  year = {2026},
  volume = {12},
  number = {11},
  pages = {497},
  doi = {10.3390/batteries12110497}
}
Kostenlos starten →