Effect of Filling Mining Sequence on Surface Subsidence Under Repeated Mining Conditions
Applied Sciences · 20.11.2026 · 16 (22) · 11516
DOI: 10.3390/app162211516 ↗Kurz gefasst
Fachartikel in der Zeitschrift Applied Sciences, online erschienen am 20.11.2026. Verfasst von Dehong Wu und 2 weiteren Autor:innen. Die Arbeit nennt 22 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China.
Abstract (Originalsprache)
Repeated mining of close-distance coal seams in the loess hilly region of northwestern China causes superimposed overburden damage that makes surface subsidence difficult to control, yet the influence of the strip-filling sequence on the final subsidence basin has rarely been quantified. Taking a mine in northwestern Shanxi Province as an engineering background, this paper compares sequential strip filling with skip-strip filling (one-strip interval) by means of three-dimensional numerical models built in MIDAS GTS NX. Seven schemes are simulated, covering single-seam and repeated extraction of seams 8 and 11 with and without filling. The results show the following. (i) Without filling, repeated mining increases the maximum surface subsidence from 0.560 m to 0.746 m, i.e., by 33.2%, and the actual subsidence exceeds the linear superposition of the two single-seam cases by 7.9–8.7%, which confirms that the superimposed disturbance is non-linear. (ii) Filling changes the roof from a hanging, tension-dominated state to a multi-point supported compressive state; it reduces the maximum subsidence by 25.4% (sequential) and 35.2% (skip-strip) in single-seam mining and by 7.2% and 9.5% under repeated mining. (iii) The advantage of skip-strip filling over sequential filling decreases from 13.2% in single-seam mining to about 2.5% under repeated mining, because pre-existing overburden damage limits the scope for process optimisation. (iv) Deformation control is direction-dependent: the advantage of skip-strip filling is clear normal to the advance direction but is weakened parallel to it, where the advancing disturbance and the gully topography cause abrupt local changes. The conclusions remain valid under mesh refinement and for backfill stiffnesses of 0.3–0.7 GPa, the advantage of skip-strip filling being stable at 2.0–2.8%. The results provide a basis for the sequencing of strip filling in close-distance seam groups.
Förderung
- National Natural Science Foundation of China
Zitieren
APA
Wu, D., Lv, Y., & Liu, Y. (2026). Effect of Filling Mining Sequence on Surface Subsidence Under Repeated Mining Conditions. Applied Sciences, 16(22), 11516. https://doi.org/10.3390/app162211516
Vancouver
Wu D, Lv Y, Liu Y. Effect of Filling Mining Sequence on Surface Subsidence Under Repeated Mining Conditions. Applied Sciences. 2026;16(22):11516. doi:10.3390/app162211516
BibTeX
@article{Wu2026,
author = {Wu, Dehong and Lv, Yiqing and Liu, Yanfei},
title = {Effect of Filling Mining Sequence on Surface Subsidence Under Repeated Mining Conditions},
journal = {Applied Sciences},
year = {2026},
volume = {16},
number = {22},
pages = {11516},
doi = {10.3390/app162211516}
}
EUVIMED