EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Concentration-Aware Model Predictive Control for Pressure–Flow Coordination in Slurry Shield Circulation Systems

Zhihua Liu, Ruiqiang Fan, Shanshan Huang, Xiaoxiong Zhou, Guangming Zhang

Applied Sciences · 18.11.2026 · 16 (22) · 11450

DOI: 10.3390/app162211450 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Applied Sciences, online erschienen am 18.11.2026. Verfasst von Zhihua Liu und 4 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: the Research and Application of Key Technologies for Intelligent Equipment in Large-Diameter Shield Tunneling.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Coordinated pressure and discharge-flow regulation is a practical challenge in slurry shield circulation systems because changes in solids concentration modify pipeline resistance and the flow required by a prescribed transport criterion. This paper investigates concentration-aware model predictive control (CA-MPC) for a reduced two-pump hydraulic circulation unit. A four-state nonlinear model describes chamber pressure, inlet and discharge flows, and well-mixed solids concentration. A locally updated prediction model and a concentration-dependent minimum discharge-flow constraint are implemented within an incremental quadratic-programming controller, subject to pump-command, rate, and chamber-pressure limits. Numerical comparisons with feedforward-assisted proportional–integral control and nominal-model MPC consider set-point changes, inlet-concentration variation, excavation disturbances, and a low-flow conflict scenario. A two-factor comparison distinguishes predictor-information updating from transport-constraint scheduling. In the latter scenario, scheduling the modeled minimum-flow constraint reduced sampled threshold-violation duration from 131.5 s to zero, at the expense of increasing flow-tracking root-mean-square error from approximately 14.0 to 48.5 L/s. Predictor-information updating alone did not improve one-step prediction accuracy in the evaluated case, and larger hydraulic mismatch degraded the constraint benefit. In the matched safety case, the proposed dynamic bound and a predeclared fixed-conservative bound both achieved zero sampled model-threshold violations; the dynamic bound reduced flow RMSE from 54.784 to 48.506 L/s. The joint sensitivity study also revealed model-defined violations for the dynamic controller under increased resistance mismatch and threshold slope. These results quantify an engineering trade-off between pressure–flow tracking and model-defined transport limits. Because the hydraulic parameters and transport threshold are not experimentally calibrated, the findings apply to the stated numerical model and do not demonstrate field-scale deposition prevention.

Förderung

  • the Research and Application of Key Technologies for Intelligent Equipment in Large-Diameter Shield Tunneling

Zitieren

APA

Liu, Z., Fan, R., Huang, S., Zhou, X., & Zhang, G. (2026). Concentration-Aware Model Predictive Control for Pressure–Flow Coordination in Slurry Shield Circulation Systems. Applied Sciences, 16(22), 11450. https://doi.org/10.3390/app162211450

Vancouver

Liu Z, Fan R, Huang S, Zhou X, Zhang G. Concentration-Aware Model Predictive Control for Pressure–Flow Coordination in Slurry Shield Circulation Systems. Applied Sciences. 2026;16(22):11450. doi:10.3390/app162211450

BibTeX
@article{Liu2026,
  author = {Liu, Zhihua and Fan, Ruiqiang and Huang, Shanshan and Zhou, Xiaoxiong and Zhang, Guangming},
  title = {Concentration-Aware Model Predictive Control for Pressure–Flow Coordination in Slurry Shield Circulation Systems},
  journal = {Applied Sciences},
  year = {2026},
  volume = {16},
  number = {22},
  pages = {11450},
  doi = {10.3390/app162211450}
}
Kostenlos starten →