EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Wind-Induced Buckling and Load Capacity of a Large Floating-Roof Tank Under Nonuniform Settlement

Tuanhai Chen, Hengchen Zhang, Yonghao Liu, Sen Gong, Liang Feng, Zhipeng Leng, Wenhua Wang

Applied Sciences · 10.11.2026 · 16 (22) · 11129

DOI: 10.3390/app162211129 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Applied Sciences, online erschienen am 10.11.2026. Verfasst von Tuanhai Chen und 6 weiteren Autor:innen. Die Arbeit nennt 30 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Innovation Yongjiang 2035 Key Research and Development Programme.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Large storage tanks are often constructed in coastal areas with relatively poor geological conditions, where foundation settlement and strong wind loads pose significant challenges to safe operation. This study investigates a 100,000 m3 large external floating-roof storage tank. A three-dimensional shell finite element model is established, and geometrically nonlinear analysis combined with the arc-length method is employed to investigate the effects of liquid level, wind direction, and settlement characteristics on the structural response and wind-resistant stability of the tank. The results show that nonuniform foundation settlement changes the initial geometry of the tank wall and causes pronounced circumferential stress redistribution near the bottom edge. The overall radial deformation of the tank is governed primarily by the settlement-induced initial deformation, whereas the additional displacement caused by wind loading is relatively small but strongly direction-dependent. As the liquid level increases, the critical wind load factor increases, and the governing buckling region shifts toward the middle and upper portions of the tank wall. The maximum critical wind load factor among the investigated wind directions is 32.31% higher than the minimum value. When the settlement amplitude increases to approximately 1.5 times the measured value, the wind load-carrying capacity begins to deteriorate at a markedly accelerated rate. In addition, settlement amplitude, harmonic order, maximum slope, and curvature jointly affect structural stability. Under the same settlement amplitude, higher-order settlement components with shorter circumferential wavelengths are more likely to cause localized bending deformation. Therefore, settlement amplitude, circumferential slope, curvature, harmonic composition, and wind direction should all be considered in the inspection and wind-resistance assessment of large storage tanks.

Förderung

  • Innovation Yongjiang 2035 Key Research and Development Programme

Zitieren

APA

Chen, T., Zhang, H., Liu, Y., Gong, S., Feng, L., Leng, Z., & Wang, W. (2026). Wind-Induced Buckling and Load Capacity of a Large Floating-Roof Tank Under Nonuniform Settlement. Applied Sciences, 16(22), 11129. https://doi.org/10.3390/app162211129

Vancouver

Chen T, Zhang H, Liu Y, Gong S, Feng L, Leng Z, et al. Wind-Induced Buckling and Load Capacity of a Large Floating-Roof Tank Under Nonuniform Settlement. Applied Sciences. 2026;16(22):11129. doi:10.3390/app162211129

BibTeX
@article{Chen2026,
  author = {Chen, Tuanhai and Zhang, Hengchen and Liu, Yonghao and Gong, Sen and Feng, Liang and Leng, Zhipeng and Wang, Wenhua},
  title = {Wind-Induced Buckling and Load Capacity of a Large Floating-Roof Tank Under Nonuniform Settlement},
  journal = {Applied Sciences},
  year = {2026},
  volume = {16},
  number = {22},
  pages = {11129},
  doi = {10.3390/app162211129}
}
Kostenlos starten →