EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Development and Performance Evaluation of a Feed Mixer-Distributor Equipped with a Leveling–Mixing Device

Daniyar Abilzhanov, Tokhtar Abilzhanuly, Nurakhmet Khamitov, Anuarbek Adilsheev, Olzhas Seipataliyev, Dauren Kosherbay

Applied Sciences · 10.07.2026 · 16 (14) · 6924

DOI: 10.3390/app16146924 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Applied Sciences, online erschienen am 10.07.2026. Verfasst von Daniyar Abilzhanov und 5 weiteren Autor:innen. Die Arbeit nennt 32 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Committee of Industry of the Ministry of Industry and Construction of the Republic of Kazakhstan.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

A hypothesis was proposed that continuous dual-circuit mixing can be achieved by equipping a feed mixer-distributor with two leveling–mixing finger shafts, which, after lifting the feed mass to a certain height, collect it in the central part of the hopper and divide it into two flows directed toward the end walls of the hopper. In this case, continuous dual-circuit mixing is performed during each rotation of the leveling–mixing shaft. A structural and technological scheme, engineering documentation, and an experimental prototype of the feed mixer-distributor were developed. The machine consists of a 3.0 m3 hopper, two horizontal augers, two leveling–mixing finger shafts, a loading conveyor, and a drive mechanism. Theoretical investigations were carried out, and analytical expressions were obtained to determine the circumferential velocity of the fingers of the leveling–mixing device. This velocity must ensure the movement of the feed mixture without scattering and guarantee the release of the feed mass from the finger surface when the finger rotation angle exceeds 20°. Calculations based on the obtained analytical expressions showed that the critical circumferential velocity of the fingers is 0.866 m/s, while the calculated minimum rotational speed of the finger shaft is 20.7 min−1. Therefore, a rotational speed of approximately 20 min−1 was adopted for the experimental investigations. Experimental studies conducted at different rotational speeds of the leveling–mixing device showed that the optimal rotational speed of the finger shaft is 20 min−1. At this rotational speed, the mixture uniformity exceeded 90%. An analytical expression was also derived to determine the velocity of feed mixture movement along the finger surface. Calculations showed that the optimal velocity ranged from 0.5 to 0.94 m/s. This value corresponds to the rational velocity of feed mixture transportation toward the end walls of the hopper. Laboratory experiments were carried out using the feed mixer-distributor at a leveling–mixing finger shaft rotational speed of n = 20 min−1. The optimal mixing time required to achieve the target mixture uniformity was 5.5 min under the tested operating conditions. Comparative experiments also showed that operation of the feed mixer-distributor without the leveling–mixing device resulted in a 34% higher power consumption than operation with the leveling–mixing device.

Förderung

  • Committee of Industry of the Ministry of Industry and Construction of the Republic of Kazakhstan

Zitieren

APA

Abilzhanov, D., Abilzhanuly, T., Khamitov, N., Adilsheev, A., Seipataliyev, O., & Kosherbay, D. (2026). Development and Performance Evaluation of a Feed Mixer-Distributor Equipped with a Leveling–Mixing Device. Applied Sciences, 16(14), 6924. https://doi.org/10.3390/app16146924

Vancouver

Abilzhanov D, Abilzhanuly T, Khamitov N, Adilsheev A, Seipataliyev O, Kosherbay D. Development and Performance Evaluation of a Feed Mixer-Distributor Equipped with a Leveling–Mixing Device. Applied Sciences. 2026;16(14):6924. doi:10.3390/app16146924

BibTeX
@article{Abilzhanov2026,
  author = {Abilzhanov, Daniyar and Abilzhanuly, Tokhtar and Khamitov, Nurakhmet and Adilsheev, Anuarbek and Seipataliyev, Olzhas and Kosherbay, Dauren},
  title = {Development and Performance Evaluation of a Feed Mixer-Distributor Equipped with a Leveling–Mixing Device},
  journal = {Applied Sciences},
  year = {2026},
  volume = {16},
  number = {14},
  pages = {6924},
  doi = {10.3390/app16146924}
}
Kostenlos starten →