EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Numerical Method and Analysis of 3-Dimension Thin Layer Model for Plate Dew Point Indirect Evaporative Cooler

Wenhe Zhou, Li Wang, Yapeng Jiang

Applied Sciences · 23.06.2026 · 16 (13) · 6306

DOI: 10.3390/app16136306 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Applied Sciences, online erschienen am 23.06.2026. Verfasst von Wenhe Zhou und 2 weiteren Autor:innen. Die Arbeit nennt 21 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Key Research and Development Program of Gansu Provincial Science and Technology Plan.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

By itself or combining with other cooling technologies, the dew point indirect evaporative cooler (DIEC) will be the preferred solution for cooling buildings. However, there are still some gaps in the research on DIEC performance, one of which is that 3-D (3-dimensional) models and methods are not widely used to comprehensively indicate the cooling mechanism. Most of the available numerical methods adopted 1-D or 2-D models. Existing 3-D models and methods either ignore the water film and plate or are so complicated in the grid system and numerical calculation induced by huge size differences among calculation regions that their attractions are weak. A novel simplified numerical method for DIEC performance is first suggested in this paper, and then, its validity and more efficiency than an existing 3-D numerical method are verified with the help of experimental data and numerical results. Finally, the effects of structure and operating parameters on the performance of a plate DIEC are analyzed by this present method and COMSOL Multiphysics 6.3 software, especially η/η0 (the reinforcement factor), which was innovatively introduced. Similar results to those of existing literature were obtained, which further indicated the practicability of this simplified method. In the conditions involved in this paper, a channel length of 1.5 m, a width of 4 mm, Rein (the Reynolds number at the inlet) of 1483, and a (the air ratio) of 0.33 are recommended. In the condition suggested by this paper, η/η0 is close to 1.2. In the same conditions, this proposed method reduces the number of mesh elements by approximately 58% and the wall-clock computational time by approximately 52% under the reported workstation conditions, and its value would be more obvious for more complicated problems.

Förderung

  • Key Research and Development Program of Gansu Provincial Science and Technology Plan

Zitieren

APA

Zhou, W., Wang, L., & Jiang, Y. (2026). Numerical Method and Analysis of 3-Dimension Thin Layer Model for Plate Dew Point Indirect Evaporative Cooler. Applied Sciences, 16(13), 6306. https://doi.org/10.3390/app16136306

Vancouver

Zhou W, Wang L, Jiang Y. Numerical Method and Analysis of 3-Dimension Thin Layer Model for Plate Dew Point Indirect Evaporative Cooler. Applied Sciences. 2026;16(13):6306. doi:10.3390/app16136306

BibTeX
@article{Zhou2026,
  author = {Zhou, Wenhe and Wang, Li and Jiang, Yapeng},
  title = {Numerical Method and Analysis of 3-Dimension Thin Layer Model for Plate Dew Point Indirect Evaporative Cooler},
  journal = {Applied Sciences},
  year = {2026},
  volume = {16},
  number = {13},
  pages = {6306},
  doi = {10.3390/app16136306}
}
Kostenlos starten →