Combustion Characteristics of CI Engine Fuelled with Distilled and Hydrotreated Plastic Pyrolytic Oil and Diesel Blends
Applied Sciences · 22.10.2025 · 15 (21) · 11318
DOI: 10.3390/app152111318 ↗Kurz gefasst
Fachartikel in der Zeitschrift Applied Sciences, online erschienen am 22.10.2025. Verfasst von Farjana Faisal und 3 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 38 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
This study examined engine combustion characteristics of the plastic diesel produced through pyrolysis of waste plastics as an eco-friendly source of engine fuel. We extensively measured and compared the key fuel properties based on various diesel fuel standards. Distillation and hydrotreatment processes were used to improve the quality of the pyrolysis oil, resulting in distilled plastic diesel (DPD) and hydrotreated plastic diesel (HPD). DPD and HPD were blended at 10:90 and 20:80 (vol%) ratios with commercial diesel, resulting in fuel blends termed as DPD10, DPD20, HPD10, and HPD20, respectively, to analyse their engine combustion characteristics. A full-scale 4-cylinder, 4-stroke diesel engine was used in this study. There are virtually no studies available in the literature where engine combustion characteristics have been tested with both distilled and hydrotreated plastic pyrolytic oil. This study comprehensively investigated the combustion behaviours of all four fuel blends under full-load conditions and at an engine operating speed of 1500 rpm, except engine exhaust gas temperature which was measured at varying engine speeds from 1200 rpm to 2400 rpm at an interval of 300 rpm. The study found notable differences in engine combustion characteristics between the commercial diesel and plastic diesel blends under identical operating conditions. The HPD blends had higher exhaust gas temperatures (EGTs) than the DPD blends, particularly at lower blend ratios, whereas the DPD10 and HPD10 blends had higher peak cylinder pressures than DPD20 and HPD20. The HPD10 blend exhibited the highest heat release rate (HRR) of 120.41 J/°CA. The engine combustion characteristics using a full-scale engine with distilled and hydrotreated plastic diesel and their comparison are not fully studied in the literature yet.
Zitieren
APA
Faisal, F., Rasul, M. G., Jahirul, M. I., & Chowdhury, A. A. (2025). Combustion Characteristics of CI Engine Fuelled with Distilled and Hydrotreated Plastic Pyrolytic Oil and Diesel Blends. Applied Sciences, 15(21), 11318. https://doi.org/10.3390/app152111318
Vancouver
Faisal F, Rasul MG, Jahirul MI, Chowdhury AA. Combustion Characteristics of CI Engine Fuelled with Distilled and Hydrotreated Plastic Pyrolytic Oil and Diesel Blends. Applied Sciences. 2025;15(21):11318. doi:10.3390/app152111318
BibTeX
@article{Faisal2025,
author = {Faisal, Farjana and Rasul, Mohammad Golam and Jahirul, Md Islam and Chowdhury, Ashfaque Ahmed},
title = {Combustion Characteristics of CI Engine Fuelled with Distilled and Hydrotreated Plastic Pyrolytic Oil and Diesel Blends},
journal = {Applied Sciences},
year = {2025},
volume = {15},
number = {21},
pages = {11318},
doi = {10.3390/app152111318}
}
EUVIMED