Optimizing Reinforcement Bar Fabrication in Construction Projects via Multi-Dimensional Applications in Building Information Modeling
Applied Sciences · 08.10.2025 · 15 (19) · 10807
DOI: 10.3390/app151910807 ↗Kurz gefasst
Fachartikel in der Zeitschrift Applied Sciences, online erschienen am 08.10.2025. Verfasst von Yu Luo und 6 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 33 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Higher Education Malaysia, Fundamental Research Grant Scheme (FRGS), Chongqing University of Science and Technology (CQUST).
Abstract (Originalsprache)
Steel reinforcement is one of the most important materials used in the construction industry. This research optimizes reinforcement bar fabrication by integrating Building Information Modeling (BIM) with visual programming in Dynamo. On-site rebar cutting and bending generate significant material waste, increasing costs and environmental impact. To address this, an intelligent Dynamo script was developed to extract detailed 3D rebar and 4D scheduling data from BIM models. The script optimizes material usage by specifying cut-off lengths to improve reuse and minimize waste. Validation through two real-world case studies demonstrated the method’s significant potential. Effectiveness was assessed using benchmarks comparing the number of bars saved, waste reduced, and overall cost savings. The study confirms that optimized fabrication significantly cuts waste and cost. Its effectiveness, however, varies with rebar type and structural component, with the most significant gains observed in medium-length bars and pile caps. By offering a novel tool for sustainable construction, this research advances BIM-enabled reinforcement design and material optimization.
Förderung
- Ministry of Higher Education Malaysia, Fundamental Research Grant Scheme (FRGS)
- Chongqing University of Science and Technology (CQUST)
Zitieren
APA
Luo, Y., Liu, Y., Liao, X., Chai, C., Chong, H., Huang, Y., & Zhou, Z. (2025). Optimizing Reinforcement Bar Fabrication in Construction Projects via Multi-Dimensional Applications in Building Information Modeling. Applied Sciences, 15(19), 10807. https://doi.org/10.3390/app151910807
Vancouver
Luo Y, Liu Y, Liao X, Chai C, Chong H, Huang Y, et al. Optimizing Reinforcement Bar Fabrication in Construction Projects via Multi-Dimensional Applications in Building Information Modeling. Applied Sciences. 2025;15(19):10807. doi:10.3390/app151910807
BibTeX
@article{Luo2025,
author = {Luo, Yu and Liu, Yiminxuan and Liao, Xiaofeng and Chai, Changsaar and Chong, Heap-Yih and Huang, Yongtong and Zhou, Zhaoyin},
title = {Optimizing Reinforcement Bar Fabrication in Construction Projects via Multi-Dimensional Applications in Building Information Modeling},
journal = {Applied Sciences},
year = {2025},
volume = {15},
number = {19},
pages = {10807},
doi = {10.3390/app151910807}
}
EUVIMED