Flowability-Dependent Anisotropic Mechanical Properties of 3D Printing Concrete: Experimental and Theoretical Study
Applied Sciences · 28.05.2025 · 15 (11) · 6070
DOI: 10.3390/app15116070 ↗Kurz gefasst
Fachartikel in der Zeitschrift Applied Sciences, online erschienen am 28.05.2025. Verfasst von Xinlei Song und 4 weiteren Autor:innen. Die Arbeit wurde bisher 12-mal zitiert (Crossref) und nennt 48 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Science Foundation of China, R&D Program of Zhejiang Province, Shanxi-Zheda Institute of New Materials and Chemical Engineering.
Abstract (Originalsprache)
Three-dimensional printing concrete (3DPC) has garnered significant attention for its construction efficiency and complex geometric capabilities. However, its mechanical properties differ markedly from cast-in-place concrete due to interlayer/intralayer interface weakening and pore anisotropy. Flowability directly regulates printability and pore distribution, thereby influencing mechanical properties. This study systematically examines flowability’s effects on 3DPC mechanical properties through compressive, flexural, and interfacial splitting tensile tests, integrated with Griffith’s fracture theory and stress intensity factor calculations. The key findings are as follows: (1) 3DPC exhibits pronounced anisotropy—compressive strength (X > Y > Z), flexural strength (Y ≈ Z > X2 > X1), and splitting tensile strength (C > T). Increased flowability enables compressive and Y/Z direction flexural strengths to approach cast concrete levels. (2) The anisotropy coefficient Ia decreases significantly with flowability (66.7% for compressive, 66.8% for flexural strength). Flexural strength shows greater sensitivity to interfacial defects than compressive strength. (3) The aspect ratio of ellipsoidal pores directly influences the anisotropic compressive behavior. Increased flowability promotes morphological transformation of elliptical pores toward more spherical geometries with reduced flattening, thereby mitigating the anisotropy in compressive performance. These results establish a theoretical framework for optimizing and predicting 3DPC mechanical performance, supporting its practical application in construction.
Förderung
- National Science Foundation of China
- R&D Program of Zhejiang Province
- Shanxi-Zheda Institute of New Materials and Chemical Engineering
- Centre for Balance Architecture, Zhejiang University
Zitieren
APA
Song, X., Xu, Q., Wang, H., Sun, X., & Xue, F. (2025). Flowability-Dependent Anisotropic Mechanical Properties of 3D Printing Concrete: Experimental and Theoretical Study. Applied Sciences, 15(11), 6070. https://doi.org/10.3390/app15116070
Vancouver
Song X, Xu Q, Wang H, Sun X, Xue F. Flowability-Dependent Anisotropic Mechanical Properties of 3D Printing Concrete: Experimental and Theoretical Study. Applied Sciences. 2025;15(11):6070. doi:10.3390/app15116070
BibTeX
@article{Song2025,
author = {Song, Xinlei and Xu, Quanbiao and Wang, Hailong and Sun, Xiaoyan and Xue, Feng},
title = {Flowability-Dependent Anisotropic Mechanical Properties of 3D Printing Concrete: Experimental and Theoretical Study},
journal = {Applied Sciences},
year = {2025},
volume = {15},
number = {11},
pages = {6070},
doi = {10.3390/app15116070}
}
EUVIMED