EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Semi-Active Vibration Control of Automotive Subframes and Seats Using Magnetorheological Elastomer Actuators

Yuta Sobue, Yusaku Yamada, Yudai Kawase, Rafid Newaj Arefin, Osamu Terashima

Actuators · 13.08.2026 · 15 (8) · 442

DOI: 10.3390/act15080442 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Actuators, online erschienen am 13.08.2026. Verfasst von Yuta Sobue und 4 weiteren Autor:innen. Die Arbeit nennt 19 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: JSPS KAKENHI, Mazak Foundation, Kansai Research Foundation for Technology Promotion.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Magnetorheological elastomers (MREs) exhibit magnetic-field-dependent stiffness and can, therefore, be used to tune the natural frequency of a dynamic vibration absorber through the applied coil current. This study evaluates the extension of a previously developed MRE-based semi-active absorber to two automotive noise, vibration, and harshness transmission paths: road-input-related subframe vibration and engine-induced seat vibration. A standard cylindrical actuator was installed below the subframe of a passenger vehicle and tested on a rough road at 10, 20, and 30 km/h. Vehicle speed was used as the operating-condition feedback variable for current selection, while additional fixed-current measurements were conducted to characterize the current-dependent response. Cabin sound pressure was measured simultaneously. A compact actuator with a lightweight resin housing was also developed for the seat application; engine speed was used as the feedback variable, and the current was selected with reference to the second-order engine excitation. The natural frequencies of both actuators increased with current, although the compact actuator had a smaller tuning range. The actuator-installed conditions produced local, current-dependent reductions in subframe and seat vibration spectra. Changes in cabin sound pressure were smaller, frequency-dependent, and not uniform. The results demonstrate the feasibility of the operating-condition-based tuning of MRE dynamic absorbers for local automotive vibration paths, while also identifying limitations associated with passive installation effects, magnetic-circuit efficiency, packaging, and multi-path cabin acoustics.

Förderung

  • JSPS KAKENHI
  • Mazak Foundation
  • Kansai Research Foundation for Technology Promotion

Zitieren

APA

Sobue, Y., Yamada, Y., Kawase, Y., Arefin, R. N., & Terashima, O. (2026). Semi-Active Vibration Control of Automotive Subframes and Seats Using Magnetorheological Elastomer Actuators. Actuators, 15(8), 442. https://doi.org/10.3390/act15080442

Vancouver

Sobue Y, Yamada Y, Kawase Y, Arefin RN, Terashima O. Semi-Active Vibration Control of Automotive Subframes and Seats Using Magnetorheological Elastomer Actuators. Actuators. 2026;15(8):442. doi:10.3390/act15080442

BibTeX
@article{Sobue2026,
  author = {Sobue, Yuta and Yamada, Yusaku and Kawase, Yudai and Arefin, Rafid Newaj and Terashima, Osamu},
  title = {Semi-Active Vibration Control of Automotive Subframes and Seats Using Magnetorheological Elastomer Actuators},
  journal = {Actuators},
  year = {2026},
  volume = {15},
  number = {8},
  pages = {442},
  doi = {10.3390/act15080442}
}
Kostenlos starten →