Passive SOBP generation from a static proton pencil beam using 3D-printed range modulators for FLASH experiments
Frontiers in Physics · 04.07.2023 · 11
DOI: 10.3389/fphy.2023.1213779 ↗Kurz gefasst
Fachartikel in der Zeitschrift Frontiers in Physics, online erschienen am 04.07.2023. Verfasst von Felix Horst und 9 weiteren Autor:innen. Die Arbeit wurde bisher 10-mal zitiert (Crossref) und nennt 38 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Istituto Nazionale di Fisica Nucleare.
Abstract (Originalsprache)
The University Proton Therapy facility in Dresden (UPTD), Germany, is equipped with an experimental room with a beamline providing a static pencil beam. High proton beam currents can be achieved at this beamline which makes it suitable for FLASH experiments. However, the established experimental setup uses only the entrance channel of the proton Bragg curve. In this work, a set of 3D-printed range modulators designed to generate spread out Bragg peaks (SOBPs) for radiobiological experiments at ultra-high dose rate at this beamline is described. A new method to optimize range modulators specifically for the case of a static pencil beam based on the central depth dose profile is introduced. Modulators for two different irradiation setups were produced and characterized experimentally by measurements of lateral and depth dose distributions using different detectors. In addition, Monte Carlo simulations were performed to assess profiles of the dose averaged linear energy transfer ( LET D ) in water. These newly produced range modulators will allow future proton FLASH experiments in the SOBP at UPTD with two different experimental setups.
Förderung
- Istituto Nazionale di Fisica Nucleare
Zitieren
APA
Horst, F., Beyreuther, E., Bodenstein, E., Gantz, S., Misseroni, D., Pugno, N. M., Schuy, C., Tommasino, F., Weber, U., & Pawelke, J. (2023). Passive SOBP generation from a static proton pencil beam using 3D-printed range modulators for FLASH experiments. Frontiers in Physics, 11. https://doi.org/10.3389/fphy.2023.1213779
Vancouver
Horst F, Beyreuther E, Bodenstein E, Gantz S, Misseroni D, Pugno NM, et al. Passive SOBP generation from a static proton pencil beam using 3D-printed range modulators for FLASH experiments. Frontiers in Physics. 2023;11. doi:10.3389/fphy.2023.1213779
BibTeX
@article{Horst2023,
author = {Horst, Felix and Beyreuther, Elke and Bodenstein, Elisabeth and Gantz, Sebastian and Misseroni, Diego and Pugno, Nicola M. and Schuy, Christoph and Tommasino, Francesco and Weber, Uli and Pawelke, Jörg},
title = {Passive SOBP generation from a static proton pencil beam using 3D-printed range modulators for FLASH experiments},
journal = {Frontiers in Physics},
year = {2023},
volume = {11},
doi = {10.3389/fphy.2023.1213779}
}
EUVIMED