Design and test a converging and de Laval nozzle using additive manufacturing
Frontiers in Aerospace Engineering · 22.08.2022 · 1
DOI: 10.3389/fpace.2022.951987 ↗Kurz gefasst
Fachartikel in der Zeitschrift Frontiers in Aerospace Engineering, online erschienen am 22.08.2022. Verfasst von Mingtai Chen und 4 weiteren Autor:innen. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 28 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
The advent of additive manufacturing technology has facilitated the design and fabrication of parts and models in both academia and aerospace industry. Compressible flow in the nozzles is not a new research topic; however, the accuracy of the experimental results obtained from the nozzles using additive manufacturing has not been assessed comprehensively. Surface roughness and strength of 3D-printed nozzles are two major concerns when they are applied to compressible flows. In this paper, a converging and a de Laval nozzle fabricated by additive manufacturing using ABS filament are designed and tested. Surface roughness inside the converging nozzle is quantified using a nondestructive method. In general, the experimental results compare well with the analytical solutions from isentropic equations for the converging nozzle and the numerical simulations conducted in ANASYS Fluent for the de Laval nozzle. 3D-printed nozzles can be employed to quickly demonstrate and verify novel ideas and concepts in the pedagogy and research at large Reynolds numbers.
Zitieren
APA
Chen, M., Baby, R., Dillard, S., Lee, Y. T., & Ekkad, S. (2022). Design and test a converging and de Laval nozzle using additive manufacturing. Frontiers in Aerospace Engineering, 1. https://doi.org/10.3389/fpace.2022.951987
Vancouver
Chen M, Baby R, Dillard S, Lee YT, Ekkad S. Design and test a converging and de Laval nozzle using additive manufacturing. Frontiers in Aerospace Engineering. 2022;1. doi:10.3389/fpace.2022.951987
BibTeX
@article{Chen2022,
author = {Chen, Mingtai and Baby, Ruksana and Dillard, Seth and Lee, Yi Tsung and Ekkad, Srinath},
title = {Design and test a converging and de Laval nozzle using additive manufacturing},
journal = {Frontiers in Aerospace Engineering},
year = {2022},
volume = {1},
doi = {10.3389/fpace.2022.951987}
}
EUVIMED