EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

The impact of cell density variations on nanoparticle uptake across bioprinted A549 gradients

Luigi Di Stolfo, Wang Sik Lee, Dimitri Vanhecke, Sandor Balog, Patricia Taladriz-Blanco, Alke Petri-Fink, Barbara Rothen-Rutishauser

Frontiers in Bioengineering and Biotechnology · 30.04.2025 · 13

DOI: 10.3389/fbioe.2025.1584635 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Frontiers in Bioengineering and Biotechnology, online erschienen am 30.04.2025. Verfasst von Luigi Di Stolfo und 6 weiteren Autor:innen. Beteiligte Einrichtung: Adolphe Merkle Institute and National Center of Competence in Research Bio-Inspired Materials, University of Fribourg, Fribourg, Switzerland. Die Arbeit wurde bisher 5-mal zitiert (Crossref) und nennt 113 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Introduction

The safe-by-design of engineered nanoparticles (NPs) for any application requires a detailed understanding of how the particles interact with single cells. Most studies are based on two-dimensional, uniformly dense cell cultures, which do not represent the diverse and inhomogeneous cell environments found in situ . In-vitro models that accurately represent tissue complexity, including realistic cell densities, are essential to increase the predictive accuracy of studies on cell-NP interactions. This study uses a bioprinted cell gradient model to examine the relation between cell density and NP uptake in one dish.

Method

A549 lung epithelial cell density gradients within single inserts were produced with a bioprinter by modulating inter-droplet distances. After two days in culture, cells were exposed to Cy5-labeled silica NPs (SiO 2 NPs, ∼112 nm, 20 μg/mL) for up to 48 h. Confocal fluorescence microscopy and 3D image analysis were used to quantify NP uptake, cell surface area, and cell volume. The relationship between NP uptake and the other parameters was then investigated statistically.

Results

Bioprinting enabled the creation of reproducible linear cell density gradients, allowing controlled modeling of density variations while preserving cell viability throughout the experiment. Increasing inter-droplet distances, from 0.1 mm to 0.6 mm, were used to achieve uniformly decreasing cell densities. SiO 2 NP uptake per cell was around 50% higher in low-density regions compared to high-density areas across all time points, i.e., 6, 24, and 48 h post-exposure. This inverse relationship correlated with greater average cell surface area in lower-density regions, while differences in the proliferation rates of the A549 cells at varying densities did not significantly impact uptake, did not significantly impact uptake.

Conclusion

SiO 2 NP uptake is significantly enhanced at lower cell densities, mainly due to the increased available surface area, revealing potential cell-NP interaction differences in tissues that present cell density variability. Our drop-on-demand bioprinting gradient model successfully supports the implementation of cell density gradients in in-vitro models to increase their relevance as new approach methodologies (NAMs) for next-generation risk assessment strategies.

Schlagwörter

Stichwörter der Autor:innen

3D image analysisSiO2 nanoparticlesadvanced in-vitro modelbioprintercell densitycell density gradientsnanoparticle uptakenanoparticle-cell membrane interaction

Autor:innen und Institutionen

  • Adolphe Merkle Institute and National Center of Competence in Research Bio-Inspired Materials, University of Fribourg, Fribourg, Switzerland.
  • Department of Chemistry, University of Fribourg, Fribourg, Switzerland.

Zitieren

APA

Di Stolfo, L., Lee, W. S., Vanhecke, D., Balog, S., Taladriz-Blanco, P., Petri-Fink, A., & Rothen-Rutishauser, B. (2025). The impact of cell density variations on nanoparticle uptake across bioprinted A549 gradients. Frontiers in Bioengineering and Biotechnology, 13. https://doi.org/10.3389/fbioe.2025.1584635

Vancouver

Di Stolfo L, Lee WS, Vanhecke D, Balog S, Taladriz-Blanco P, Petri-Fink A, et al. The impact of cell density variations on nanoparticle uptake across bioprinted A549 gradients. Frontiers in Bioengineering and Biotechnology. 2025;13. doi:10.3389/fbioe.2025.1584635

BibTeX
@article{DiStolfo2025,
  author = {Di Stolfo, Luigi and Lee, Wang Sik and Vanhecke, Dimitri and Balog, Sandor and Taladriz-Blanco, Patricia and Petri-Fink, Alke and Rothen-Rutishauser, Barbara},
  title = {The impact of cell density variations on nanoparticle uptake across bioprinted A549 gradients},
  journal = {Frontiers in Bioengineering and Biotechnology},
  year = {2025},
  volume = {13},
  doi = {10.3389/fbioe.2025.1584635}
}
Kostenlos starten →