EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC 4.0

Variable turbine geometry for an automotive turbocharger with a small axial turbine

Christoph Kuestner, Eike Helmsen, Joerg R. Seume

Journal of the Global Power and Propulsion Society · 11.03.2026 · 10 · 61-73

DOI: 10.33737/jgpps/208541 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of the Global Power and Propulsion Society, online erschienen am 11.03.2026. Verfasst von Christoph Kuestner und 2 weiteren Autor:innen. Die Arbeit nennt 20 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The paper examines the implementation of a variable turbine geometry (VTG) and the reduction of its tip leakage losses in a small axial turbine turbocharger for charging lean-burn internal combustion engines. Due to the small turbine size, a reduction in the number of vanes and a redesign was required to match the design point of the non-adjustable stator. Subsequently, disks were added to the vanes’ ends to seal the radial gaps in the VTG. The turbine size prohibited a full sealing on the hub side, leaving small gaps at the leading edge (LE) and trailing edge (TE). To evaluate their influence, three gap configurations of the adjusted design (constant hub gap, partial gaps at LE and TE, and non-gap) were compared with the initial design using CFD simulations. The results showed that the partial gap configuration was able to reduce the maximum mass flow rate deviations at the investigated turbine speed down to 0.8% while maintaining the same turbine efficiencies as the non-gap configuration. Finally, the performance map was evaluated for the partial gap configuration, which showed that the turbine required a slightly larger pivot angle range to meet the specified requirements.

Zitieren

APA

Kuestner, C., Helmsen, E., & Seume, J. R. (2026). Variable turbine geometry for an automotive turbocharger with a small axial turbine. Journal of the Global Power and Propulsion Society, 10, 61-73. https://doi.org/10.33737/jgpps/208541

Vancouver

Kuestner C, Helmsen E, Seume JR. Variable turbine geometry for an automotive turbocharger with a small axial turbine. Journal of the Global Power and Propulsion Society. 2026;10:61-73. doi:10.33737/jgpps/208541

BibTeX
@article{Kuestner2026,
  author = {Kuestner, Christoph and Helmsen, Eike and Seume, Joerg R.},
  title = {Variable turbine geometry for an automotive turbocharger with a small axial turbine},
  journal = {Journal of the Global Power and Propulsion Society},
  year = {2026},
  volume = {10},
  pages = {61--73},
  doi = {10.33737/jgpps/208541}
}
Kostenlos starten →