Evaluation of the surface quality and coating integrity of teak (Tectona grandis L.f.) with different finishing systems
Mobilya ve Ahşap Malzeme Araştırmaları Dergisi · 16.11.2026 · (Advanced Online Publication)
DOI: 10.33725/mamad.2022700 ↗Kurz gefasst
Fachartikel in der Zeitschrift Mobilya ve Ahşap Malzeme Araştırmaları Dergisi, online erschienen am 16.11.2026. Verfasst von Aralyn Quintos-Cortiguerra und 3 weiteren Autor:innen. Die Arbeit nennt 35 Literaturangaben. Gefördert von: Department of Science and Technology-Forest Products Research and Development Institute.
Abstract (Originalsprache)
The objective of this study was to evaluate and compare the performance of different finishing systems on plantation-grown teak (Tectona grandis) to optimize its aesthetics and mechanical protection. Four topcoats such as nitrocellulose (NC) lacquer, solvent-based polyurethane (PU), water-based polyurethane (PUW) and alkyd varnish (VA) were evaluated in combination with straight, oil (O), and non-grain-raising (NGR) stains on plantation teak. PU produced "closed-grain" finishes with highest dry film thickness (DFT). Conversely, the NC system exhibited lowest DFT yielding an "open-grain" finish with high surface roughness (Ra, Rq and Rz). Surface topography directly influenced optical properties. PU achieved the highest Distinctness of Image (DOI) and gloss, while NC’s surface irregularities resulted in poor image clarity. PU recorded the highest König and pencil hardness. However, oil-stain reduced König hardness in PU and VA systems. The PU system, which yielded low adhesion by tape test ratings recorded the highest pull-off strength. Ultimately, PU offers the highest durability and bond strength, while PUW serves as a high-performance, low-VOC alternative. The study concludes that topcoat-stain interactions are critical, as specific stains can significantly reduced the performance properties of the final finish.
Förderung
- Department of Science and Technology-Forest Products Research and Development Institute
Zitieren
APA
Quintos-Cortiguerra, A., Benjo, S., Elec, J., & Tagolabong, A. (2026). Evaluation of the surface quality and coating integrity of teak (Tectona grandis L.f.) with different finishing systems. Mobilya ve Ahşap Malzeme Araştırmaları Dergisi. https://doi.org/10.33725/mamad.2022700
Vancouver
Quintos-Cortiguerra A, Benjo S, Elec J, Tagolabong A. Evaluation of the surface quality and coating integrity of teak (Tectona grandis L.f.) with different finishing systems. Mobilya ve Ahşap Malzeme Araştırmaları Dergisi. 2026. doi:10.33725/mamad.2022700
BibTeX
@article{QuintosCortiguerra2026,
author = {Quintos-Cortiguerra, Aralyn and Benjo, Salvatierra and Elec, Jovito and Tagolabong, Ailene},
title = {Evaluation of the surface quality and coating integrity of teak (Tectona grandis L.f.) with different finishing systems},
journal = {Mobilya ve Ahşap Malzeme Araştırmaları Dergisi},
year = {2026},
number = {Advanced Online Publication},
doi = {10.33725/mamad.2022700}
}
EUVIMED