Process-property Relationships in Fused Filament Fabrication of 17-4PH Stainless Steel: Effects of Printing Parameters on Tensile Strength, Shrinkage, and Defect-sensitive Behavior
Periodica Polytechnica Transportation Engineering · 16.11.2026
DOI: 10.3311/pptr.40046 ↗Kurz gefasst
Fachartikel in der Zeitschrift Periodica Polytechnica Transportation Engineering, online erschienen am 16.11.2026. Verfasst von György Ledniczky und 2 weiteren Autor:innen.
Abstract (Originalsprache)
This study investigates the effect of selected Fused Filament Fabrication parameters on the tensile behavior and dimensional change of 17-4PH stainless steel specimens produced from BASF Ultrafuse filament. Layer height, printing speed, and infill angle were evaluated using a Taguchi-based experimental design, while the printed parts were subsequently subjected to catalytic debinding and sintering. Tensile testing of the as-sintered specimens showed that the best-performing parameter combination reached 802 MPa, corresponding to approximately 80% of the tensile strength reported by the material supplier. The statistical analysis identified layer height as the most influential factor, followed by infill angle, whereas printing speed had a smaller effect within the investigated range. In addition to the primary tensile and shrinkage evaluation, supplementary dimensional, density-related, and fracture-surface observations were used to support the interpretation of the results. These findings indicate that the final mechanical response cannot be explained solely by nominal printing settings, but must be understood through their effect on green-part integrity, densification, shrinkage, and internal defect formation during post-processing. Overall, the results show that the performance of extrusion-based 17-4PH stainless steel parts is governed by the combined effect of deposition strategy and thermal treatment, and that reliable parameter selection can significantly improve the mechanical quality of sintered components.
Zitieren
APA
Ledniczky, G., Bognár, A., & Kun, K. (2026). Process-property Relationships in Fused Filament Fabrication of 17-4PH Stainless Steel: Effects of Printing Parameters on Tensile Strength, Shrinkage, and Defect-sensitive Behavior. Periodica Polytechnica Transportation Engineering. https://doi.org/10.3311/pptr.40046
Vancouver
Ledniczky G, Bognár A, Kun K. Process-property Relationships in Fused Filament Fabrication of 17-4PH Stainless Steel: Effects of Printing Parameters on Tensile Strength, Shrinkage, and Defect-sensitive Behavior. Periodica Polytechnica Transportation Engineering. 2026. doi:10.3311/pptr.40046
BibTeX
@article{Ledniczky2026,
author = {Ledniczky, György and Bognár, Adrián and Kun, Krisztián},
title = {Process-property Relationships in Fused Filament Fabrication of 17-4PH Stainless Steel: Effects of Printing Parameters on Tensile Strength, Shrinkage, and Defect-sensitive Behavior},
journal = {Periodica Polytechnica Transportation Engineering},
year = {2026},
doi = {10.3311/pptr.40046}
}
EUVIMED