EUVIMEDEUVIMED entdecken
Crossref

The Study of Optimal Molding of a LED Lens with Grey Relational Analysis and Molding Simulation

Min-Wen Wang, Fatahul Arifin, Van-Hanh Vu

Periodica Polytechnica Mechanical Engineering · 23.08.2019 · 63 (4) · 278-294

DOI: 10.3311/ppme.13337 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Periodica Polytechnica Mechanical Engineering, online erschienen am 23.08.2019. Verfasst von Min-Wen Wang und 2 weiteren Autor:innen. Die Arbeit wurde bisher 17-mal zitiert (Crossref).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Injection molding technology is known as the most widely used method in mass production of plastic products. To meet the quality requirements, a lot of methods were applied in optimization of injection molding process parameter. In this study the optimization based on Taguchi orthogonal array and Grey relational analysis (GRA) is used to optimize the injection molding process parameters on a LED lens. The four process parameters are: packing pressure, injection speed, melt temperature and mold temperature. The multi-response quality characteristics are total displacement, volumetric shrinkage, and thermal residual stress. The optimal molding parameters are packing pressure (90 MPa), injection speed (300 mm/sec), melt temperature (270 °C) and mold temperature (90 °C). The luminous uniformity of the LED is 92.61 % and the viewing angle of the LED is 124.76°. Among the four factors, packing pressure plays the key role in reducing total displacement, volumetric shrinkage, and thermal residual stress.

Zitieren

APA

Wang, M., Arifin, F., & Vu, V. (2019). The Study of Optimal Molding of a LED Lens with Grey Relational Analysis and Molding Simulation. Periodica Polytechnica Mechanical Engineering, 63(4), 278-294. https://doi.org/10.3311/ppme.13337

Vancouver

Wang M, Arifin F, Vu V. The Study of Optimal Molding of a LED Lens with Grey Relational Analysis and Molding Simulation. Periodica Polytechnica Mechanical Engineering. 2019;63(4):278-294. doi:10.3311/ppme.13337

BibTeX
@article{Wang2019,
  author = {Wang, Min-Wen and Arifin, Fatahul and Vu, Van-Hanh},
  title = {The Study of Optimal Molding of a LED Lens with Grey Relational Analysis and Molding Simulation},
  journal = {Periodica Polytechnica Mechanical Engineering},
  year = {2019},
  volume = {63},
  number = {4},
  pages = {278--294},
  doi = {10.3311/ppme.13337}
}
Kostenlos starten →