EUVIMEDEUVIMED entdecken
Crossref

Non-process elements in the lime cycle: New findings regarding NPE distribution and lime mud filterability

Marta Bialik, Nestor Salvador Palacios, Anna Jensen, Kristoffer Guthenberg

TAPPI Journal · 31.07.2026 · 25 (7) · 395

DOI: 10.32964/tj25.7.395 ↗

Kurz gefasst

Fachartikel in der Zeitschrift TAPPI Journal, online erschienen am 31.07.2026. Verfasst von Marta Bialik und 3 weiteren Autor:innen. Die Arbeit nennt 21 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Proper functioning of the recausticizing cycle is crucial for securing a stable white liquor supply for a pulp mill. Common runnability problems in the modern lime cycle, such as low filterability and poor dewatering of lime mud, high dead load, or ring formation in the lime kiln, are often caused by accumulation of non-process elements (NPEs). This project attempted to verify the traditional rules of thumb regarding the chemical behavior of NPEs: magnesium (Mg), aluminum (Al), silicon (Si), phosphorus (P), zinc (Zn), manganese (Mn), iron (Fe), copper (Cu), barium (Ba), cadmium (Cd), and lead (Pb) in the causticizing reaction, and to investigate the reasons behind poor lime mud filterability. First, a standardized method for measuring filterability of lime mud was developed. Next, a series of recausticizing experiments, followed by immediate filtration trials, was conducted using mill green liquors, laboratory-made synthetic green liquor, reburned lime/makeup mix, and extra NPE additions. It was found that sodium (Na), potassium (K), and sulfur (S) followed the liquid phase, as expected, while Mg, P, and Ba, but also Pb, Cu, and Cd, showed low solubility and accumulated in the lime mud. The Si and Al accumulated in the lime mud even though the soluble content in liquor was high, while the behavior of Mn, Fe, and Zn was more complex. Based on these results, tentative solubility limits for NPEs were suggested as a first estimate for the maximum possible concentrations of NPEs in mill white liquor. The causticization-filtration experiments revealed that overliming and high content of Mg in green liquor clearly led to lower filterability, but our addition of Si did not have such an effect. As differences in particle size and size distribution have a certain impact on the filtration resistance, the lime mud sedimentation behavior, combined with other characterization methods, might be used as an indication for the filterability. Finally, a list of recommendations for pulp mills was formulated that starts with establishing a comprehensive standard for a lime mud with good filterability. This standard can be used as a benchmark for comparison any time a lime cycle runnability problem is identified.

Zitieren

APA

Bialik, M., Palacios, N. S., Jensen, A., & Guthenberg, K. (2026). Non-process elements in the lime cycle: New findings regarding NPE distribution and lime mud filterability. TAPPI Journal, 25(7), 395. https://doi.org/10.32964/tj25.7.395

Vancouver

Bialik M, Palacios NS, Jensen A, Guthenberg K. Non-process elements in the lime cycle: New findings regarding NPE distribution and lime mud filterability. TAPPI Journal. 2026;25(7):395. doi:10.32964/tj25.7.395

BibTeX
@article{Bialik2026,
  author = {Bialik, Marta and Palacios, Nestor Salvador and Jensen, Anna and Guthenberg, Kristoffer},
  title = {Non-process elements in the lime cycle: New findings regarding NPE distribution and lime mud filterability},
  journal = {TAPPI Journal},
  year = {2026},
  volume = {25},
  number = {7},
  pages = {395},
  doi = {10.32964/tj25.7.395}
}
Kostenlos starten →