EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-SA 4.0

Limitations of Interlocking Features in Rotary Friction Welding (RFW) of 3D-printed PLA

Fauzan Al Fathurrahman, Fathur Rahman Naufal Santoso, Erwin, Didik Sugiyanto, Juan Pratama

Jurnal Rekayasa Mesin · 01.05.2026 · 21 (1) · 31-38

DOI: 10.32497/jrm.v21i1.7419 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Jurnal Rekayasa Mesin, online erschienen am 01.05.2026. Verfasst von Fauzan Al Fathurrahman und 4 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref). Der Volltext ist frei zugänglich (Open Access, CC BY-NC-SA 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The limited build volume of fused deposition modeling (FDM) often necessitates the use of joining methods for larger components. However, the effectiveness of interlocking features in the RFW of 3D-printed polymers remains unclear. This study investigates the limitations of interlocking features in RFW of polylactic acid (PLA) by evaluating the effect of male-female geometry on the joint performance. The results show that all interlocked RFW joints exhibit significantly reduced tensile strength, reaching only approximately 30% of the control samples, accompanied by decreased ductility. Despite variations in the interlock geometry, no significant improvement in joint performance was observed. Failure analysis indicates that the excessive weld flash accumulation within the interlocking region generates internal pressure, which restricts material flow and promotes crack initiation. This leads to localized plastic deformation followed by brittle failure at the joint interface. These findings demonstrate that the interlocking geometry does not necessarily enhance joint quality in RFW of 3D-printed PLA and may introduce inherent limitations if not properly designed. This study highlights the critical role of material flow and geometric constraints in governing joint performance, emphasizing the need for optimized interlock design and process control in thermoplastic friction welding.

Zitieren

APA

Fathurrahman, F. A., Santoso, F. R. N., Erwin, Sugiyanto, D., & Pratama, J. (2026). Limitations of Interlocking Features in Rotary Friction Welding (RFW) of 3D-printed PLA. Jurnal Rekayasa Mesin, 21(1), 31-38. https://doi.org/10.32497/jrm.v21i1.7419

Vancouver

Fathurrahman FA, Santoso FRN, Erwin, Sugiyanto D, Pratama J. Limitations of Interlocking Features in Rotary Friction Welding (RFW) of 3D-printed PLA. Jurnal Rekayasa Mesin. 2026;21(1):31-38. doi:10.32497/jrm.v21i1.7419

BibTeX
@article{Fathurrahman2026,
  author = {Fathurrahman, Fauzan Al and Santoso, Fathur Rahman Naufal and Erwin and Sugiyanto, Didik and Pratama, Juan},
  title = {Limitations of Interlocking Features in Rotary Friction Welding (RFW) of 3D-printed PLA},
  journal = {Jurnal Rekayasa Mesin},
  year = {2026},
  volume = {21},
  number = {1},
  pages = {31--38},
  doi = {10.32497/jrm.v21i1.7419}
}
Kostenlos starten →