Effect of reinforcement areal weight on laminate thickness in unidirectional carbon fiber reinforced composites
Journal of Structural Engineering & Applied Mechanics · 05.07.2025 · 9 (2)
DOI: 10.31462/jseam.2026.654 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Structural Engineering & Applied Mechanics, online erschienen am 05.07.2025. Verfasst von Gülnur Başer und 1 weiteren Autor:innen.
Abstract (Originalsprache)
Carbon fiber–reinforced plastics (CFRPs) are extensively utilized in aerospace, defense, automotive, and marine applications owing to their high specific stiffness and strength. Although unidirectional (UD) prepreg systems provide superior mechanical performance, their high material and processing costs have motivated increasing interest in textile-based reinforcements and out-of-autoclave manufacturing techniques, such as vacuum-assisted resin infusion (VARI). In VARI processes, laminate thickness is not constrained by a rigid mold cavity and is therefore strongly governed by the reinforcement architecture and resin uptake behavior. In this study, the influence of the areal weight (AW) of unidirectional carbon fiber reinforcement on laminate thickness in vacuum-infused composites is systematically investigated. Non-crimp stitched UD carbon fabrics, with measured carbon areal weights ranging from 596.6 to 634.9 g/m², were manufactured by varying the tow density across the fabric width. The compaction behavior of dry fabrics was evaluated using 100-ply stacks under vacuum, while the thickness and fiber volume fraction of cured laminates were determined from 20-ply infused specimens. The results demonstrate a strong linear correlation between carbon AW and cured ply thickness (CPT) (R² ≈ 0.93), indicating that laminate thickness increases predictably with increasing reinforcement mass per unit area. Specifically, an increase of 10 g/m² in carbon AW corresponds to an average increase of approximately 0.035 mm in CPT. Similarly, the dry stack thickness under vacuum exhibits a strong linear dependence on AW (R² ≈ 0.90), whereas the fiber volume fraction (FVF) shows a slight decreasing trend with increasing AW. These findings provide quantitative design guidelines for thickness prediction and reinforcement selection in infusion-based manufacturing of unidirectional CFRP laminates, particularly for applications where geometric constraints are minimal or absent.
Zitieren
APA
Başer, G., & Aygün, B. (2025). Effect of reinforcement areal weight on laminate thickness in unidirectional carbon fiber reinforced composites. Journal of Structural Engineering & Applied Mechanics, 9(2). https://doi.org/10.31462/jseam.2026.654
Vancouver
Başer G, Aygün B. Effect of reinforcement areal weight on laminate thickness in unidirectional carbon fiber reinforced composites. Journal of Structural Engineering & Applied Mechanics. 2025;9(2). doi:10.31462/jseam.2026.654
BibTeX
@article{Baer2025,
author = {Başer, Gülnur and Aygün, Berk},
title = {Effect of reinforcement areal weight on laminate thickness in unidirectional carbon fiber reinforced composites},
journal = {Journal of Structural Engineering & Applied Mechanics},
year = {2025},
volume = {9},
number = {2},
doi = {10.31462/jseam.2026.654}
}
EUVIMED