EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

Structural and optical analysis of amorphous TiO2 films pbtained by sol-gel process and deposited by spin coating on PET/ITO at room temperature

CARLOS MONTERO-TAVERA, Mariely Loeza Poot, Moises Oviedo Mendoza, Joel Moreno-Palmerín, Wilma Betzabe Rojas-Salinas, Felipe Caballero-Briones, Martín Zapata-Torres, Eric Noe Hernandez Ramirez

Revista Mexicana de Física · 01.07.2026 · 72 (4) · 1-7

DOI: 10.31349/revmexfis.72.041001 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Revista Mexicana de Física, online erschienen am 01.07.2026. Verfasst von CARLOS MONTERO-TAVERA und 7 weiteren Autor:innen. Die Arbeit nennt 45 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In this work, we proposed a methodology based on the spin coating technique for the deposition of amorphous TiO2 layers obtained by the sol-gel method onto flexible PET/ITO substrates intended for application in flexible organic solar cells (FOSCs). Spin-coated TiO2 layers were used to investigate the influence of their optical and structural properties on the light absorption behavior of the P3HT:PCBM active layer, to integrate the photovoltaic system PET/ITO/TiO2/P3HT:PCBM. Raman spectroscopy confirmed the amorphous nature of TiO2. The average particle size was 216 nm according to SEM results. UV-Vis measurements of TiO2 layers showed a transmittance greater than 65% and a bandgap of 3.77 eV, which corresponds to the bandgap of amorphous TiO2, making them a novel material for electromagnetic radiation to reach the P3HT:PCBM absorber layer and generate excitons within it. A high light absorbance zone (300-550 nm) and a weak light zone (650-900 nm) were found. FT-IR spectra revealed the characteristic absorbance bands of Ti−O at 523 cm-1 and Ti−O−Ti at 434 cm-1. AFM images revealed a uniform distribution of TiO2 onto PET/ITO, and the typical P3HT:PCBM microstructure. This methodology enables the deposition of TiO2 layers at room temperature without the use of any additional chemical bonding agents, which is a key factor for low - temperature fabrication of FOSCs.

Zitieren

APA

MONTERO-TAVERA, C., Poot, M. L., Mendoza, M. O., Moreno-Palmerín, J., Rojas-Salinas, W. B., Caballero-Briones, F., Zapata-Torres, M., & Ramirez, E. N. H. (2026). Structural and optical analysis of amorphous TiO2 films pbtained by sol-gel process and deposited by spin coating on PET/ITO at room temperature. Revista Mexicana de Física, 72(4), 1-7. https://doi.org/10.31349/revmexfis.72.041001

Vancouver

MONTERO-TAVERA C, Poot ML, Mendoza MO, Moreno-Palmerín J, Rojas-Salinas WB, Caballero-Briones F, et al. Structural and optical analysis of amorphous TiO2 films pbtained by sol-gel process and deposited by spin coating on PET/ITO at room temperature. Revista Mexicana de Física. 2026;72(4):1-7. doi:10.31349/revmexfis.72.041001

BibTeX
@article{MONTEROTAVERA2026,
  author = {MONTERO-TAVERA, CARLOS and Poot, Mariely Loeza and Mendoza, Moises Oviedo and Moreno-Palmerín, Joel and Rojas-Salinas, Wilma Betzabe and Caballero-Briones, Felipe and Zapata-Torres, Martín and Ramirez, Eric Noe Hernandez},
  title = {Structural and optical analysis of amorphous TiO2 films pbtained by sol-gel process and deposited by spin coating on PET/ITO at room temperature},
  journal = {Revista Mexicana de Física},
  year = {2026},
  volume = {72},
  number = {4},
  pages = {1--7},
  doi = {10.31349/revmexfis.72.041001}
}
Kostenlos starten →