EUVIMEDEUVIMED entdecken
Crossref

Wellbore Cool Down During Hydraulic Fracturing Simplifies Using Dissolvable Materials

Michael Fripp

Progress in Petrochemical Science · 2018

DOI: 10.31031/pps.2018.02.000528 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Progress in Petrochemical Science, 2018. Verfasst von Michael Fripp.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Dissolvable materials are enabling a revolution in terms of the completion and stimulation of wellbores. The advantage of dissolvable materials is particularly evident in their use for hydraulic fracturing where the frac plugs and the frac balls can be constructed entirely from dissolvable materials. Unconventional reservoirs, such as shale formations, typically become economical when the surface area of the reservoir contact is increased, and one of the most effective and economical methods of increasing the reservoir contact is through multistage hydraulic fracturing [1]. Frac plugs and balls are used to isolate previously fractured zones and to direct the flow to the next fracture stage. In the plug-andperf approach to hydraulic fracturing, the frac plug and guns are pumped into the wellbore to the location where zonal isolation is necessary [2]. After the plug is set, perforations are made in the casing above the frac plug using perforation guns and completion fluid and sand are pumped into the wellbore to stimulate the perforated zone while the frac plug isolates the zones below. This method of plug-and-perf is repeated until the target number of pay zones has been completed. However, the frac plugs remain in the wellbore, which can create restrictions to production. Full production requires that the frac plug be removed. Traditionally, composite type frac plugs were frequently used because they could be easily milled out [2]. New dissolvable frac plugs reduce the likelihood of needing to mill out the plugs. These dissolvable plugs are constructed from dissolvable metal, plastic, and elastomer. They are designed to dissolve away in typical completion fluids once the fracturing operation is completed, thus eliminating the milling process [3]. If dissolvable type frac plugs were used during fracturing, then a lower cost wellbore cleanup can be used rather than the process used for a longer duration milling operation. Dissolvable fracturing tools allow for lower cost hydraulic fracturing with a quicker time to production and allows for the construction of extended reach laterals [4]. Research Article

Zitieren

APA

Fripp, M. (2018). Wellbore Cool Down During Hydraulic Fracturing Simplifies Using Dissolvable Materials. Progress in Petrochemical Science. https://doi.org/10.31031/pps.2018.02.000528

Vancouver

Fripp M. Wellbore Cool Down During Hydraulic Fracturing Simplifies Using Dissolvable Materials. Progress in Petrochemical Science. 2018. doi:10.31031/pps.2018.02.000528

BibTeX
@article{Fripp2018,
  author = {Fripp, Michael},
  title = {Wellbore Cool Down During Hydraulic Fracturing Simplifies Using Dissolvable Materials},
  journal = {Progress in Petrochemical Science},
  year = {2018},
  doi = {10.31031/pps.2018.02.000528}
}
Kostenlos starten →