EUVIMEDEUVIMED entdecken
Crossref

The Review of Flue Gas Desulfurization with a Readily Available Metal Ions Liquid Catalytic Oxidation Catalyst-Pulp

Ping Ning

Progress in Petrochemical Science · 2018

DOI: 10.31031/pps.2018.02.000526 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Progress in Petrochemical Science, 2018. Verfasst von Ping Ning. Die Arbeit wurde bisher 1-mal zitiert (Crossref).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Introduction As one of the main atmospheric pollutants, SO2is the immediate cause of acid rain, which can result in dead trees, food production decrease, water acidification, building corrosion, deterioration of ecological environment, and serious harm to human health [1]. SO2is mainly derived from flue gas emissions of the thermal power industry, nonmetal mineral products industry, chemical industry and metallurgy industry [2]. Scholars did a lot of research on flue gas desulfurization, and developed more than one hundred kinds of desulfurization methods, divided into dry and wet kinds according to the forming process [3]. In the industrialization methods, limestone-gypsum was used mostly, which was cheap and produced by-product gypsum, while the gypsum was difficult to be used, economic was not obvious, and it caused the secondary pollution [4]. Developing a new desulphurization technology which can not only remove SO2from flue gas, but also recycle sulfur resources to get high value by-product will be an effective way to solve SO2pollution. In recent years, liquid phase catalytic oxidation flue gas desulfurization technology are paid more and more attention[5,6], such as Mn(II) system, Fe(II) and Fe(III) system, various ions coordinated system, heteropoly acid system, which don’t consume catalyst in theory, and can regenerate by changing valence state of transition metal ions, without solid waste and secondary pollution. In addition, it can make valuable by-products, fertilizer, ferrous sulfate, manganese sulfate, polymeric ferric sulfate, and so on. By investigation, the addition of Mn, Cu, Co to Fe(II)catalyst , not only can play promoting and synergy performance, but also make Fe(II) catalytic activity stable, and the absorbing liquid used to remove SO2from smelter flue gas has achieved good effect [7]. From the view of sulfur resource utilization, environment protection and sustainable development, recycling method should be chosen firstly in flue gas desulfurization.

Zitieren

APA

Ning, P. (2018). The Review of Flue Gas Desulfurization with a Readily Available Metal Ions Liquid Catalytic Oxidation Catalyst-Pulp. Progress in Petrochemical Science. https://doi.org/10.31031/pps.2018.02.000526

Vancouver

Ning P. The Review of Flue Gas Desulfurization with a Readily Available Metal Ions Liquid Catalytic Oxidation Catalyst-Pulp. Progress in Petrochemical Science. 2018. doi:10.31031/pps.2018.02.000526

BibTeX
@article{Ning2018,
  author = {Ning, Ping},
  title = {The Review of Flue Gas Desulfurization with a Readily Available Metal Ions Liquid Catalytic Oxidation Catalyst-Pulp},
  journal = {Progress in Petrochemical Science},
  year = {2018},
  doi = {10.31031/pps.2018.02.000526}
}
Kostenlos starten →