Heavy Fuel Oil Recovery from Oil Sludge by Multiple Extraction Processes
Progress in Petrochemical Science · 2018
DOI: 10.31031/pps.2018.01.000517 ↗Kurz gefasst
Fachartikel in der Zeitschrift Progress in Petrochemical Science, 2018. Verfasst von Isam Al Zubaidi. Die Arbeit wurde bisher 6-mal zitiert (Crossref).
Abstract (Originalsprache)
The petroleum refining industry generates relatively large quantities of waste sludge from various sources including tank bottoms; slop oil emulsion solids and various sludges from oil/ water/solids separation. The accumulation of crude storage tank bottoms is a comparatively serious problem experienced by most refineries. The settling out of the sand, corrosion product and heavy fractions in the crude oil results in a loss of ullage in refinery crude storage tanks and causes refinery problems when introducing this sludge to the refinery processes. This may cause a fouling in the tubes of heat exchangers and solids/emulsions can pass from one area to another, which can result in downtime in production and frequent maintenance will require. Previously oil sludge had been disposed of at landfill sites and lagoons, valuable hydrocarbons have been sent offsite, which has both environmental and financial implications. Now, the disposal has become unacceptable, alternative solutions where oil recovery, re-use, and recycling can take place [1]. Solvent extraction can separate light hydrocarbons, which can be used as fuel. Petroleum refinery sludges typically comprise three phases and multiple components. They mainly consist of 20-90 wt% water, 5-40 wt% oil, and about 5-35 wt% solids. It is shown that oily sludge is a water-in-oil emulsion, stabilized by fine solids [2]. The performance of several solvents to extract fuel oil from oily sludge was compared using many solvents [3]. MEK has the highest performance for fuel oil recovery. The amount of asphaltene in fuel oil was related to the concentration of fuel oil in the solvent phase during the extraction. This can be reached to the conclusion that asphaltene is extracted mainly by the fuel oil components, not the solvent [4]. The addition of commercial oil-water demulsifier increased the recovery of heavy fuel oil [5]. The effect of the addition of KOH to the solvent to enhance the recovery process of fuel oil from oil sludge was investigated [6].
Zitieren
APA
Zubaidi, I. A. (2018). Heavy Fuel Oil Recovery from Oil Sludge by Multiple Extraction Processes. Progress in Petrochemical Science. https://doi.org/10.31031/pps.2018.01.000517
Vancouver
Zubaidi IA. Heavy Fuel Oil Recovery from Oil Sludge by Multiple Extraction Processes. Progress in Petrochemical Science. 2018. doi:10.31031/pps.2018.01.000517
BibTeX
@article{Zubaidi2018,
author = {Zubaidi, Isam Al},
title = {Heavy Fuel Oil Recovery from Oil Sludge by Multiple Extraction Processes},
journal = {Progress in Petrochemical Science},
year = {2018},
doi = {10.31031/pps.2018.01.000517}
}
EUVIMED