Influence of Plastic-Cold Deformation on Mechanical Properties and Fatigue Crack Growth Behaviour of Annealed Al6061 Alloy
Journal of Sustainable Materials Processing and Management · 13.10.2026 · 6 (2)
DOI: 10.30880/jsmpm.2026.06.02.006 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Sustainable Materials Processing and Management, online erschienen am 13.10.2026. Verfasst von Dedy Rizaldy und 3 weiteren Autor:innen.
Abstract (Originalsprache)
Improving the strength of annealed Al6061 without compromising formability remains a key challenge. This study investigates plastic-cold deformation (PCD) using nominal compressive stresses of 10 MPa (PCD10) and 18 MPa (PCD18) as a simple approach to strengthen the alloy. Although the applied stress was lower, PCD10 produced a more concentrated near-surface hardened layer than PCD18, accompanied by higher tensile strength and better fatigue crack growth (FCG) resistance. PCD10 sustained approximately 55% more fatigue cycles to failure, with more pronounced crack-growth retardation at low stress intensity factor range (K), a lower Paris exponent (m= 3.16 vs 3.57), and a higher maximum stress intensity factor at failure (Kmax= 24.01 vs 19.36 MPa·m1/2). Fractographic and energy-dispersive X-ray spectroscopy (EDS) analyses showed that Fe-rich intermetallic particles were associated with local microvoidnucleation and crack-path deviation in both conditions. The more contained fracture morphology observed for PCD10 was consistent with its lower fatigue crack-growth rate. Overall, the results show that the spatial distribution of near-surface plastic deformation has a greater influence on the mechanical and fatigue behaviour of gripping-induced PCD than nominal compressive stress alone. Localised contact deformation therefore provides a simple and energy-efficient route for improving the structural performance of annealed Al6061.
Zitieren
APA
Rizaldy, D., Geris, D. F., Badaruddin, M., & Sugiyanto (2026). Influence of Plastic-Cold Deformation on Mechanical Properties and Fatigue Crack Growth Behaviour of Annealed Al6061 Alloy. Journal of Sustainable Materials Processing and Management, 6(2). https://doi.org/10.30880/jsmpm.2026.06.02.006
Vancouver
Rizaldy D, Geris DF, Badaruddin M, Sugiyanto. Influence of Plastic-Cold Deformation on Mechanical Properties and Fatigue Crack Growth Behaviour of Annealed Al6061 Alloy. Journal of Sustainable Materials Processing and Management. 2026;6(2). doi:10.30880/jsmpm.2026.06.02.006
BibTeX
@article{Rizaldy2026,
author = {Rizaldy, Dedy and Geris, Dwiandra Fadhila and Badaruddin, Mohammad and Sugiyanto},
title = {Influence of Plastic-Cold Deformation on Mechanical Properties and Fatigue Crack Growth Behaviour of Annealed Al6061 Alloy},
journal = {Journal of Sustainable Materials Processing and Management},
year = {2026},
volume = {6},
number = {2},
doi = {10.30880/jsmpm.2026.06.02.006}
}
EUVIMED