Validation of a 3D numerical model for piled raft systems founded in soft soils undergoing regional subsidence
Soils and Rocks · 2021
DOI: 10.28927/sr.2021.053620 ↗Kurz gefasst
Fachartikel in der Zeitschrift Soils and Rocks, 2021. Verfasst von Andrea J. Alarcón Posse und 4 weiteren Autor:innen. Die Arbeit wurde bisher 6-mal zitiert (Crossref).
Abstract (Originalsprache)
On many occasions, commercial software based on numerical models are used indiscriminately for the analysis of complex problems without a real understanding of the problem. Also, by ignoring the influence that different geotechnical parameters have on the simulation results. The cases of instrumented structures and/or physical models in laboratory allow obtaining results closer to reality and with a clearer understanding of the phenomenon. However, these results may be limited by the number of case studies, model dimensions, number of variables, time of assembly and execution, type and quantity of instruments and problems related to the installation of the instruments and during monitoring. Regarding the numerical models, they can be calibrated and validated through the results produced by the physical tests and, at the same time, be used to obtain additional results. This calibration and validation process is complex since it must consider the selection of the constitutive model, the adjustment of the parameters, the definition of the initial stress states and pore pressure, and the definition of the analysis stages. The result of this process allows developing a better understanding of the sensitivity of the different parameters and a more realistic analysis methodology. In this paper, the case of a piled raft system used on soft soils undergoing regional subsidence was studied. According to Alnuaim et al. (2018), a piled raft is a composite structure with three components: subsoil, raft, and piles. The structural components interact with each other and with the surrounding soil (pile-soil, raft-soil, and pile-raft) to bear vertical, horizontal, and moment loads coming from the superstructure. Luo et al. (2018) refer to this system as an effective foundation due to its efficiency in reducing settlements and improving bearing capacity. Many papers have been presented to understand the behavior of piled raft systems using different ways of approaching (field test, laboratory test, and numerical modeling). The use of numerical modeling has increased considerably, and it has been used as a tool that allows simulating the behavior of complex structures in real projects. Some models have been Abstract In this paper a 3D numerical model using a software based on the Finite Element Method (FEM), was developed and validated using the results obtained in a geotechnical centrifuge model of a piled raft system founded in soft soils undergoing regional subsidence. The piled raft configuration had nine piles distributed in the center of the raft. The kaolin parameters were obtained, calibrated, and validated for the Hardening Soil Model (HSM), based on laboratory triaxial and oedometer test results. Also, a single pile load test was carried out in the centrifuge to get the resistance parameters used in the FEM. The developed numerical model reproduced satisfactorily soil and foundation consolidation displacements due, not only by the structural service load but also by the pore pressure drawdown. For load distribution on piles and raft, the model reproduces with good agreement the foundation behavior only for the structural service load, for pore pressure drawdown some adjustments on the embedded piles elements shaft and base resistance had to be done. The developed model allowed to identify the most sensitive parameters for this type of simulation, to define the types and stages of analysis that had the best fit for the physical model, and to obtain additional results to those measured in the physical model, e.g., the axial load distribution developed along the piles and therefore the magnitude of the negative skin friction, that is an important load that should be considered for the structural safety review of piled foundations subjected to this complex conditions.
Zitieren
APA
Posse, A. J. A., Rebolledo, J. F. R., García, J. A. B., Hormaza, B. C., & Rodríguez-Rincón, E. (2021). Validation of a 3D numerical model for piled raft systems founded in soft soils undergoing regional subsidence. Soils and Rocks. https://doi.org/10.28927/sr.2021.053620
Vancouver
Posse AJA, Rebolledo JFR, García JAB, Hormaza BC, Rodríguez-Rincón E. Validation of a 3D numerical model for piled raft systems founded in soft soils undergoing regional subsidence. Soils and Rocks. 2021. doi:10.28927/sr.2021.053620
BibTeX
@article{Posse2021,
author = {Posse, Andrea J. Alarcón and Rebolledo, Juan F. Rodríguez and García, Julián A. Buriticá and Hormaza, Bernardo Caicedo and Rodríguez-Rincón, Edgar},
title = {Validation of a 3D numerical model for piled raft systems founded in soft soils undergoing regional subsidence},
journal = {Soils and Rocks},
year = {2021},
doi = {10.28927/sr.2021.053620}
}
EUVIMED