EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC 4.0

Geometry-Driven Inertia Variation in Submarine Ballast Tanks during Blowing and Limitations of Simplified Models

Jae Sang Jung, Sung wook Lee

Journal of Ocean Engineering and Technology · 31.10.2026 · 40 (5) · 549-564

DOI: 10.26748/ksoe.2026.041 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Ocean Engineering and Technology, erschienen am 31.10.2026. Verfasst von Jae Sang Jung und 1 weiteren Autor:innen. Die Arbeit nennt 14 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Predicting submarine motion during emergency rising requires accurate estimation of the moments of inertia during ballast tank blowing, yet prior studies approximate tanks as simple cubes or cylinders that may not reflect real mass distributions. This study develops a voxelization framework that computes moments of inertia directly from computer-aided design geometry without simplification. Three tanks of identical volume and mass (cube, cylinder, and U-shaped) were analyzed under stepwise blowing (100–40% mass) and pitch rotation (0–30 degrees), and the resulting inertia was coupled with the hull inertia. At full mass, the U-shaped tank showed 113.3% and 50.0% higher roll-axis inertia (Ixx) than the cube and cylinder, respectively. Ixx decreased by 55–57% as mass fell to 40%, with a further 9–11% reduction under a 30-degree pitch rotation for the cylinder and U-shaped tanks but none for the cube. When coupled with the hull inertia, the geometry-induced difference in total inertia remained within 3.3% for the roll axis and below 0.1% for the pitch and yaw axes, for which the position inertia term dominates. Tank geometry therefore strongly affects tank self-inertia but influences overall submarine inertia only in roll motion, governed by Ixx. The proposed approach offers an efficient tool for evaluating simplified ballast tank models.

Zitieren

APA

Jung, J. S., & Lee, S. W. (2026). Geometry-Driven Inertia Variation in Submarine Ballast Tanks during Blowing and Limitations of Simplified Models. Journal of Ocean Engineering and Technology, 40(5), 549-564. https://doi.org/10.26748/ksoe.2026.041

Vancouver

Jung JS, Lee SW. Geometry-Driven Inertia Variation in Submarine Ballast Tanks during Blowing and Limitations of Simplified Models. Journal of Ocean Engineering and Technology. 2026;40(5):549-564. doi:10.26748/ksoe.2026.041

BibTeX
@article{Jung2026,
  author = {Jung, Jae Sang and Lee, Sung wook},
  title = {Geometry-Driven Inertia Variation in Submarine Ballast Tanks during Blowing and Limitations of Simplified Models},
  journal = {Journal of Ocean Engineering and Technology},
  year = {2026},
  volume = {40},
  number = {5},
  pages = {549--564},
  doi = {10.26748/ksoe.2026.041}
}
Kostenlos starten →