EUVIMEDEUVIMED entdecken
Crossref

Effect of FDM Process Parameters on the Mechanical Properties and Production Costs of 3D Printed PowerABS Samples

Menderes KAM, Ahmet İPEKÇİ, Ömer ŞENGÜL

International Journal of Analytical, Experimental and Finite Element Analysis (IJAEFEA) · 30.09.2020 · 7 (3)

DOI: 10.26706/ijaefea.3.7.20200806 ↗

Kurz gefasst

Fachartikel in der Zeitschrift International Journal of Analytical, Experimental and Finite Element Analysis (IJAEFEA), online erschienen am 30.09.2020. Verfasst von Menderes KAM und 2 weiteren Autor:innen. Die Arbeit wurde bisher 11-mal zitiert (Crossref).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The main objective of this study is to analyze of the effect of fused deposition modelling (FDM) printing process parameters on the mechanical properties, printing times and production costs of samples printed with Power Acrylonitrile Butadiene Styrene (PowerABS) filament using a three-dimensional (3D) printer. This study is primarily focused on the effects of the mechanical properties of 3D samples subjected to the influence of three factors; layer thickness (0.15, 0.2, and 0.25 mm), raster angle (15, 45, and 75), table orientation (flat, horizontal, and vertical). For the experiment study, analytical methods such as regression analysis, variance analysis (ANOVA), Signal / Noise (S / N) ratio were used to determine the effect of FDM printing parameters on the mechanical properties with Taguchi optimization method. The results showed that 45° raster angle the highest mechanical properties at each individual layer when compared to 15° and 75°. The results also found tensile strength to directly proportionate to layer thickness. As observed in the results, by improving the material properties, it will be possible to provide support for mechanical engineers and designers to reduce printing time, filament material use and printing costs. Keywords— FDM, mechanical properties, optimization, PowerABS, production cost, Taguchi

Zitieren

APA

KAM, M., İPEKÇİ, A., & ŞENGÜL, Ö. (2020). Effect of FDM Process Parameters on the Mechanical Properties and Production Costs of 3D Printed PowerABS Samples. International Journal of Analytical, Experimental and Finite Element Analysis (IJAEFEA), 7(3). https://doi.org/10.26706/ijaefea.3.7.20200806

Vancouver

KAM M, İPEKÇİ A, ŞENGÜL Ö. Effect of FDM Process Parameters on the Mechanical Properties and Production Costs of 3D Printed PowerABS Samples. International Journal of Analytical, Experimental and Finite Element Analysis (IJAEFEA). 2020;7(3). doi:10.26706/ijaefea.3.7.20200806

BibTeX
@article{KAM2020,
  author = {KAM, Menderes and İPEKÇİ, Ahmet and ŞENGÜL, Ömer},
  title = {Effect of FDM Process Parameters on the Mechanical Properties and Production Costs of 3D Printed PowerABS Samples},
  journal = {International Journal of Analytical, Experimental and Finite Element Analysis (IJAEFEA)},
  year = {2020},
  volume = {7},
  number = {3},
  doi = {10.26706/ijaefea.3.7.20200806}
}
Kostenlos starten →