EUVIMEDEUVIMED entdecken
Crossref

Investigations Of The Influence Of Filler On The Impact Properties Of Polyamides And Its Composites

MITHUN KULKARNI

i-manager's Journal on Mechanical Engineering · 2011

DOI: 10.26634/jme.1.4.1539 ↗

Kurz gefasst

Fachartikel in der Zeitschrift i-manager's Journal on Mechanical Engineering, 2011. Verfasst von MITHUN KULKARNI. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 8 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Recent work has shown that due to the impacts that result during an accidental drop of a portable electronic product or any material, the proclivity for damage to the product can significantly be higher than in a single impact (Desmond Y.R. Chong., 2005) . Impact testing provides engineers with information about a plastic's toughness. The tests measure the relative inclination of plastics to fracture under stresses applied at high speeds. Impact tests allow designers to compare the relative impact resistance under controlled laboratory conditions and, consequently, are often used for material selection or quality control. Traditional impact tests measure energy required to cause failure. However they do not provide good information about mechanism or nature of failure, such as brittle or ductile failure, because these tests are generally not instrumented to measure stress and strain in the specimen during the test. Impact resistance is one of the important mechanical properties of material. In Impact resistance test, impact resistance of material is tested under impact load to determine the tenacity or break resistance of polymer material under high-speed impact. Different material or different purpose may adopt different impact testing method. The commonly used methods include Izod and charpy impact test, falling weight impact test. (Brown, 2002) In falling weight impact test the impact resistance is measured by dropping known weights on the specimen from varying heights, or a test weight is raised to a selected height and then released. The flat specimen is placed on a support plate. This method does not require notching and is believed to be better for materials which exhibit ductile behavior. The impact energy is calculated based on weight dropped, height from which weight is dropped and geometry of the striker. The test is usually performed by incrementally raising a given weight higher, and then dropping till failure is observed. The test requires larger number of specimens and average impact energy is usually based on failure of half of the specimens for a given weight-height combination. Results for different materials can only be compared when specimen thickness is the same and the tests are conducted with similar striker, support plate, drop

Zitieren

APA

KULKARNI, M. (2011). Investigations Of The Influence Of Filler On The Impact Properties Of Polyamides And Its Composites. i-manager's Journal on Mechanical Engineering. https://doi.org/10.26634/jme.1.4.1539

Vancouver

KULKARNI M. Investigations Of The Influence Of Filler On The Impact Properties Of Polyamides And Its Composites. i-manager's Journal on Mechanical Engineering. 2011. doi:10.26634/jme.1.4.1539

BibTeX
@article{KULKARNI2011,
  author = {KULKARNI, MITHUN},
  title = {Investigations Of The Influence Of Filler On The Impact Properties Of Polyamides And Its Composites},
  journal = {i-manager's Journal on Mechanical Engineering},
  year = {2011},
  doi = {10.26634/jme.1.4.1539}
}
Kostenlos starten →