Methods Of Placement And Installation Of Ufm To Extend The Linearity Range Of Measurement
i-manager's Journal on Instrumentation and Control Engineering · 2013
DOI: 10.26634/jic.1.4.2600 ↗Kurz gefasst
Fachartikel in der Zeitschrift i-manager's Journal on Instrumentation and Control Engineering, 2013. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 20 Literaturangaben.
Abstract (Originalsprache)
Flow measurement is the quantification of bulk fluid movement. Flow can be measured in a variety of ways, may be by contact type or non-contact type of sensor. Positive-displacement flow meters accumulate a fixed volume of fluid and then count the number of times the volume is filled to measure flow. Other indirect flow measurement methods rely on forces produced by the flowing stream as it overcomes a known constriction [7-9]. Flow may be measured by measuring the velocity of fluid over a known area. 1. Ultrasonic Flow Meter Ultrasonic flow meters have gained a lot of attention over the past years, primarily because of their ability for measuring custody transfer of natural gas. They are replacing differential pressure and turbine flow meters in many natural gas applications. Ultrasonic Flowmeters are also widely used to measure liquid flow. This is not limited to clean liquids either [5-6]. A special type of Ultrasonic Flowmeter can accurately measure the flow of slurries and By liquids with many impurities. Ultrasonic flow meters are one of the most interesting types of meters used to measure flow in pipes. There are two types of Ultrasonic techniques available in the Market used for the measurement of the Flow in pipes which are follows. 1.1 Doppler Method This method needs reflectors in the process. Due to malfunctioning, and incorrect application, there is feeling of uncertainty, in ultrasonic flow measurement. Instead of tracking the time it takes to cross the other side, it relies on having the signal deflected by particles in the flowstream. These particles are traveling at the same speed of the flow [10]. Therefore, as the signal passes through the stream, its frequency shifts in proportion to the mean velocity of the fluid. A receiver detects the reflected signal and measures its frequency as shown in Figure 1. The meter calculates flow by comparing the generated and detected frequencies. Doppler method relies on reflectors in the flowing liquid. To
Zitieren
APA
(2013). Methods Of Placement And Installation Of Ufm To Extend The Linearity Range Of Measurement. i-manager's Journal on Instrumentation and Control Engineering. https://doi.org/10.26634/jic.1.4.2600
Vancouver
Methods Of Placement And Installation Of Ufm To Extend The Linearity Range Of Measurement. i-manager's Journal on Instrumentation and Control Engineering. 2013. doi:10.26634/jic.1.4.2600
BibTeX
@article{euvimed2013,
title = {Methods Of Placement And Installation Of Ufm To Extend The Linearity Range Of Measurement},
journal = {i-manager's Journal on Instrumentation and Control Engineering},
year = {2013},
doi = {10.26634/jic.1.4.2600}
}
EUVIMED