Numerická analýza konštrukcie vnútorného rámu podvozka koľajového vozidla
Technológ · 2026 · 18 (3) · 14-18
DOI: 10.26552/tech.c.2026.3.2 ↗Kurz gefasst
Fachartikel in der Zeitschrift Technológ, 2026. Verfasst von Martin Bučko und 3 weiteren Autor:innen.
Abstract (Originalsprache)
This paper focuses on the static analysis of the frames of two-axle bogies for rail vehicles intended for regional passenger transport, carried out using the Finite Element Method (FEM) in the Ansys environment. The subject of the analysis is a welded frame structure made of S355J2 steel, to which operational loads corresponding to real vertical and, where applicable, lateral forces acting during vehicle operation were applied. The aim of the calculation was to verify whether the stress and deformation states of the frame satisfy the required strength and stiffness criteria. The results of the static analysis showed that the maximum equivalent stresses in the frame structure do not exceed the yield strength or the ultimate tensile strength of the material used (355 MPa), thereby ensuring the safety and sufficient load-bearing capacity of the structure. The maximum frame displacements ranged approximately between 2.05 mm and 0.84 mm, respectively, indicating a suitably designed combination of torsional flexibility - allowing the absorption of track irregularities - and sufficient stiffness required for lateral stability of the vehicle. The analysis thus confirms that the designed bogie frames meet the specified strength and deformation requirements and are suitable for operational deployment. This work also demonstrates the applicability of static FEM analysis in the Ansys environment as a tool for the design and modernization of rail vehicle bogies, aiming to increase their reliability, safety, and operational service life while maintaining the requirements of sustainable rail transport.
Zitieren
APA
Bučko, M., Samaš, V., Slušňák, P., & Dižo, J. (2026). Numerická analýza konštrukcie vnútorného rámu podvozka koľajového vozidla. Technológ, 18(3), 14-18. https://doi.org/10.26552/tech.c.2026.3.2
Vancouver
Bučko M, Samaš V, Slušňák P, Dižo J. Numerická analýza konštrukcie vnútorného rámu podvozka koľajového vozidla. Technológ. 2026;18(3):14-18. doi:10.26552/tech.c.2026.3.2
BibTeX
@article{Buko2026,
author = {Bučko, Martin and Samaš, Vladimír and Slušňák, Patrik and Dižo, Ján},
title = {Numerická analýza konštrukcie vnútorného rámu podvozka koľajového vozidla},
journal = {Technológ},
year = {2026},
volume = {18},
number = {3},
pages = {14--18},
doi = {10.26552/tech.c.2026.3.2}
}
EUVIMED