EUVIMEDEUVIMED entdecken
Crossref

Integrácia generatívneho navrhovania a kovovej aditívnej výroby pri vývoji objímky prievlaku pre ťahanie bezšvíkových rúr

Ladislav Morovič, Marcel Kuruc, Jozef Bílik

Technológ · 2026 · 18 (1) · 32-39

DOI: 10.26552/tech.c.2026.1.6 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Technológ, 2026. Verfasst von Ladislav Morovič und 2 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The paper addresses the conceptual integration of generative design and metal additive manufacturing in the development of a drawing die holder intended for the cold drawing of seamless steel tubes. Conventional die design is predominantly based on empirical rules and proven geometric configurations, which limits the systematic optimization of material distribution and control of the stress state within the tool body. Generative design methods enable the creation of lightweight and mechanically efficient structures based on defined boundary conditions, loading scenarios, and material parameters, while their practical implementation requires advanced manufacturing technologies. The study defines a methodological framework for the generative design of a drawing die holder, including the specification of preserved geometry, obstacle regions, boundary conditions, and applied loads. The resulting design variants are evaluated in terms of stress distribution, material efficiency, and technological feasibility using additive and hybrid manufacturing approaches. The limitations of metal additive manufacturing, particularly regarding dimensional accuracy, surface quality, and anisotropy of mechanical properties, are shortly also discussed.

Zitieren

APA

Morovič, L., Kuruc, M., & Bílik, J. (2026). Integrácia generatívneho navrhovania a kovovej aditívnej výroby pri vývoji objímky prievlaku pre ťahanie bezšvíkových rúr. Technológ, 18(1), 32-39. https://doi.org/10.26552/tech.c.2026.1.6

Vancouver

Morovič L, Kuruc M, Bílik J. Integrácia generatívneho navrhovania a kovovej aditívnej výroby pri vývoji objímky prievlaku pre ťahanie bezšvíkových rúr. Technológ. 2026;18(1):32-39. doi:10.26552/tech.c.2026.1.6

BibTeX
@article{Morovi2026,
  author = {Morovič, Ladislav and Kuruc, Marcel and Bílik, Jozef},
  title = {Integrácia generatívneho navrhovania a kovovej aditívnej výroby pri vývoji objímky prievlaku pre ťahanie bezšvíkových rúr},
  journal = {Technológ},
  year = {2026},
  volume = {18},
  number = {1},
  pages = {32--39},
  doi = {10.26552/tech.c.2026.1.6}
}
Kostenlos starten →