EUVIMEDEUVIMED entdecken
Crossref

MODEL BASED ROBOT CALIBRATION TECHNIQUE WITH CONSIDERATION OF JOINT COMPLIANCE

Hoai-Nhan Nguyen, Trong-Hai Nguyen, Dinh-Tung Vo, Quoc-Phuong Pham

JOURNAL OF TECHNOLOGY & INNOVATION · 2020

DOI: 10.26480/jtin.01.2021.06.09 ↗

Kurz gefasst

Fachartikel in der Zeitschrift JOURNAL OF TECHNOLOGY & INNOVATION, 2020. Verfasst von Hoai-Nhan Nguyen und 3 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Robot accuracy plays an important role for robot based application in advanced industry. Especially, robot accuracy decreases because of structural deformation when robot carries heavy load. Identification of physical robot parameters improves its accuracy by updating robot model parameters which are used in robot controller. This research presents identification technique of robot geometric parameters and its joint deformation joint angle. The target of the paper is comparison of two cases 1) only geometric calibration and 2) geometric and joint deformation angles calibration. Simulation calibration is performed on a Hyundai 800 robot which is designed for carrying heavy loads. The robot position accuracy after calibration demonstrates the effectiveness and correctness of the method.

Zitieren

APA

Nguyen, H., Nguyen, T., Vo, D., & Pham, Q. (2020). MODEL BASED ROBOT CALIBRATION TECHNIQUE WITH CONSIDERATION OF JOINT COMPLIANCE. JOURNAL OF TECHNOLOGY & INNOVATION. https://doi.org/10.26480/jtin.01.2021.06.09

Vancouver

Nguyen H, Nguyen T, Vo D, Pham Q. MODEL BASED ROBOT CALIBRATION TECHNIQUE WITH CONSIDERATION OF JOINT COMPLIANCE. JOURNAL OF TECHNOLOGY & INNOVATION. 2020. doi:10.26480/jtin.01.2021.06.09

BibTeX
@article{Nguyen2020,
  author = {Nguyen, Hoai-Nhan and Nguyen, Trong-Hai and Vo, Dinh-Tung and Pham, Quoc-Phuong},
  title = {MODEL BASED ROBOT CALIBRATION TECHNIQUE WITH CONSIDERATION OF JOINT COMPLIANCE},
  journal = {JOURNAL OF TECHNOLOGY & INNOVATION},
  year = {2020},
  doi = {10.26480/jtin.01.2021.06.09}
}
Kostenlos starten →